WAPAKONETA, OHIO—
Midwest Elastomers, Inc.
Direct exposure to electricity, greater than 220 volts · Second degree electrical burns
Final narrative
On September 18, 2019, at approximately 20:30 hours, an employee was replacing three fluorescent light units with LED light units in the HR office. The lights were turned off using two toggle switches, but were still energized. While installing the second LED light unit, the employee sustained an electric shock, second degree burns to his right hand, and a labral tear and crushing injury to the right shoulder.
Similar incidents · Same event type
S COFFEYVILLE, OKLAHOMA—
Star Pipe USA LLC
An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.
MIDLAND, TEXAS—
Star Electric Company of Texas
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
CLEARWATER, FLORIDA—
Powertown Line Construction LLC
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
WILLARD, OHIO—
Stanley Black and Decker, Inc
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
KERSEY, COLORADO—
Sun Valley Contractors, LLC
An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.