OSHA Inspection: FPM CONTINUOUS PROCESSING, INC.

Issued

1999-03-31 00:00:00

Abate by

1999-05-03 00:00:00

Penalty

Initial $875.00 · Current $400.00 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The
employer did not furnish
employment and a place of employment which were free from recognized
hazards that were
likely to cause death or serious physical harm to employees in that
employees were exposed to
being struck by a falling custom made lifting device:
FPM Processing. Custom made grab hooks were used throughout the plant to
lift drums and
rotors.  Feasible and acceptable abatement methods include, but are not
necessarily limited to:
Comply with ANSI B30.20 - Below the Hook Lifting Devices and:
1.Provide the rated load on any custom made lifting device:
2.Design the lifting device to withstand the forces imposed by its rated
load with
a minimum design factor of 3.
3.Provide initial, frequent, and periodic inspections of the lifting
devices.
4.Ensure that initial proof testing of 125of the rated load was
conducted.
CERTIFICATION AND DOCUMENTATION REQUIRED FOR THIS ITEM.

Issued

1999-03-31 00:00:00

Abate by

1999-05-03 00:00:00

Penalty

Initial $525.00 · Current $400.00 Reduced

Issued

1999-03-31 00:00:00

Abate by

1999-05-03 00:00:00

Penalty

Initial $875.00 · Current $400.00 Reduced

Issued

1999-03-31 00:00:00

Abate by

1999-04-05 00:00:00

Penalty

Initial $875.00 · Current $300.00 Reduced

Issued

1999-03-31 00:00:00

Abate by

1999-04-05 00:00:00

Penalty

Initial $525.00 · Current $300.00 Reduced