OSHA Inspection: DNRB DBA FAST TRACK ERECTORS

Issued

2009-07-06 00:00:00

Abate by

2009-08-20 00:00:00

Penalty

Initial $375.00 · Current $375.00

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards
that were causing or likely to cause death or serious physical harm to
employees in that
employees were exposed to the hazards of electric shock due to the
inadequate inspections of
a Terex Scissors Lift, TS25RT:
a/  At the job site, employees operating the Terex Scissors Lift, TS25RT,
were exposed to
the hazard of electric shock due to the complete absence of outer
insulation belonging to
flexible cord leading to the "joy stick".  This unsafe condition occurred
because of the
inadequate inspections performed.
One method of abatement to correct this apparent hazard is to begin the
development and
implementation of both frequent (monthly) and periodic (annual)
inspections of all scissors
lifts as required by ANSI A92.6-1999, paragraph 6.4.3.
DISCLAIMER:
a/  The employer is not limited to the abatement method(s) suggested by
OSHA.
b/  The employer is responsible for selecting and implementing an
effective abatement
method.
ABATEMENT CERTIFICATION AND ABATEMENT VERIFICATION ARE REQUIRED
FOR THIS VIOLATION.

Issued

2009-07-06 00:00:00

Abate by

2009-07-09 00:00:00

Penalty

Initial $375.00 · Current $375.00

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards
that were causing or likely to cause death or serious physical harm to
employees in that
employees were exposed to the hazards of falling:
a/  At the job site, employees climbed over the standard guardrail system
belonging to a
Terex Scissors Lift, TS25RT, to gain access to the metal roof deck.  The
fall distance to the
ground below was approximately 20 feet.
One method of abatement is to provide a scissors lift or the equivalent
with a pre-fabricated
gate to provide the employees with safe access to the metal roof deck as
required by ANSI
A92.6-1999, paragraph 7.10(9).
DISCLAIMER:
a/  The employer is not limited to the abatement method(s) suggested by
OSHA.
b/  The employer is responsible for selecting and implementing an
effective abatement
method.nt

Issued

2009-07-06 00:00:00

Abate by

2009-07-09 00:00:00

Penalty

Initial $375.00 · Current $375.00

Issued

2009-07-06 00:00:00

Abate by

2009-07-09 00:00:00

Penalty

Initial $300.00 · Current $300.00

Issued

2009-07-06 00:00:00

Abate by

2009-08-20 00:00:00

Penalty

Initial $300.00 · Current $300.00