OSHA Inspection: JOSE AMAYA

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Penalty

Initial $2550.00 · Current $1750.00 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to being crushed or struck by: a) Rooftop Buildings 173-176:
On or about May
3, 2011, carpenters were observed installing roof trusses that were not
being braced and were
exposed to a hazard of being crush/struck by collapsing roof trusses and
an 8'2" to a 30'7" fall
hazard. Among other methods, one feasible and acceptable abatement method
to correct this
hazard is to install bracing and hoist the trusses in accordance with the
Wood Truss Council of
America (WTC) recommendations per BCSI-B1 " Guide for Handling,
Installing, Restraining
& Bracing of Trusses".
Abatement Certification Required

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Penalty

Initial $2550.00

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to being struck: (a) Buildings 173-176:  On or about May 3,
2011, carpenters
were performing hoisting and installation of residential roof trusses and
were exposed to a struck
by hazard when lifting each 34 foot long wood trusses by a single pick
point with a double
legged wire rope sling. The use of a single pick point to lift truss may
cause lateral bending of
the truss. Among other methods, one feasible and acceptable abatement
methods to correct this
hazard is to install bracing and hoist the trusses in accordance with the
Wood Truss Council of
America (WTC) recommendations per BCSI-B1 " Guide for Handling,
Installing, Restraining
& Bracing of Trusses".
Abatement Certification Requiredation

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Penalty

Initial $1530.00

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Penalty

Initial $4200.00 · Current $2100.00 Reduced

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Penalty

Initial $1530.00 · Current $710.00 Reduced

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00

Issued

2011-07-01 00:00:00

Abate by

2011-07-05 00:00:00