Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: WALL WORKS CONSTRUCTION INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of WALL WORKS CONSTRUCTION INC. in 16000 HWY 6 SOUTH, SANTA FE, TX 77510 (NAICS 238310). OSHA activity number 315723460.

Watch Wall Works Construction INC. — free Get an email when a new federal OSHA severe-injury report for Wall Works Construction INC. is published. One employer, no account, unsubscribe in one click.
Site address
16000 HWY 6 SOUTH
City
SANTA FE
State
TX
ZIP
77510
Mailing
1900 BLADLOCK STE L, HOUSTON, TX 77080
Inspection type
Referral (C)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238310
SIC code (legacy)
1742
Employees
20
Ownership type
A
Industry flags
Construction safety.

2 citations on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $4620.00 · Current $3234.00 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The
employer did not furnish
employment and a place of employment which were free from recognized
hazards that were
causing or likely to cause death or serious physical harm to employees, in
that ; employees were
exposed to struck-by, caught in between and falls from elevated heights,
when the employer
failed to ensure a Genie Aerial lift, Model number Z-40, Serial number
Z4ON11-955, was
operated in accordance with the operator's manual, which states "do not
raise or extend the
boom unless the machine is on FIRM, level surface". This violation was
observed on or about
December 3, 2011, in the new auditorium of the Santa Fe High School, where
employees were
instructed to work from the basket of an extended boom on a Genie Arial
lift while it was on
an unlevel/uneven surface. As a result, the Arial lift over turned and an
employee was pinned
in the basket against the wall and the other was pinned between the basket
and the brick wall.
ABATEMENT NOTE:
Among other procedures, one feasible and acceptable abatement method to
correct the hazard
is for the employer to ensure management and the operators are aware and
understand the
requirements in the operator's manual.
Disclaimer:
You are not limited to the abatement methods described above.
The method explained is general and may not be effective in all cases.
The employer is responsible for selecting and carrying out an appropriate
abatement method.
Pursuant to 29 CFR 1903.19, within ten (10) calendar days of the date of
the citation, the
employer must provide documentation that it is in compliance with the
standard, including
describing the steps that it is taking to ensure that the abatement is
complete.
Recent events (2)
  • — I (S) $3234.00
  • — Z (S) $4620.00

1926.453 B02 VII

Serious Gravity 05 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $3300.00 · Current $2310.00 Reduced
Recent events (2)
  • — I (S) $2310.00
  • — Z (S) $3300.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 315723460.