OSHA Inspection: CENTRANZ

Issued

2012-06-14 00:00:00

Penalty

Initial $4410.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.23(c)(1):     Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards:      On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee was performing work operations on an upper tier with a fall height greater than 9 feet without any guard rails.       Abatement certification for this violation is not required.

Issued

2012-06-14 00:00:00

Penalty

Initial $1205.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.37(b)(2):     Each exit was not clearly visible and marked by a sign reading "Exit":      On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee's were exposed to a working facility that was without proper exits signs on exit doors.       Abatement certification for this violation is not required.

Issued

2012-06-14 00:00:00

Penalty

Initial $1607.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.215(a)(2):     Abrasive wheel(s) used on grinding machinery were not provided with safety guard(s) which covered the spindle end, nut, flange projections:      On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee was exposed to an 8 inch bench grinder without safety guards.       Abatement certification for this violation is not required.

Issued

2012-06-14 00:00:00

Penalty

Initial $1205.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.253(b)(4)(iii):     Oxygen cylinders in storage were not separated from fuel-gas cylinders or combustible materials (especially oil or grease), a minimum distance of 20 feet:    On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee was exposed to acetylene and oxygen tanks in storage that were not separated by 20 feet.      Abatement certification for this violation is not required.

Issued

2012-06-14 00:00:00

Penalty

Initial $1205.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.303(g)(1)(i):     Work space was less than 30 inches wide in front of electric equipment operating at 600 volts, nominal, or less:    On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee's were performing work operations in a room that had a blocked electrical service panel.      Abatement certification for this violation is not required.

Issued

2012-06-14 00:00:00

Penalty

Initial $4410.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.303(g)(2)(i):     Except as elsewhere required or permitted by Subpart S of Part 1910, live parts of electric equipment operating  at 50 volts or more were not guarded against accidental contact by use of approved cabinets or other forms of approved enclosures or by any of the means identified in paragraphs (A), (B), (C), and (D) of 29 CFR 1910.303(g)(2)(i):      On or about May 22nd, 2012 at worksite 27208 E. HWY 24 in Buckner, Missouri- Employee was exposed to live parts of electrical equipment.      Abatement certification for this violation is not required.