OSHA Inspection: WATTON ENTERPRISES

Issued

2013-04-25 00:00:00

Abate by

2013-06-14 00:00:00

Penalty

Initial $1600.00 · Current $1120.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s):     (a) Machining Area; Two Monarch Machine Tool Co. Lathes (4109-CC732 and 26239) were operated without guarding the rotating chuck.

Issued

2013-04-25 00:00:00

Abate by

2013-06-14 00:00:00

Penalty

Initial $1600.00 · Current $1120.00 Reduced

General-duty citation text

29 CFR 1910.147(d)(2): The machine or equipment was not turned off or shut down using the procedures established for the machine or equipment:     (a) Machining Area; Machinery such as, but not limited to, the Mazak CNC vertical and horizontal machining center(s), the Mazak CNC Slant Turn 25 ATC M/C, and the Super Quick Turn (s/n 107948) were not shut down when servicing equipment.

Issued

2013-04-25 00:00:00

Abate by

2013-06-12 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(d)(3): All energy isolating devices that were needed to control the energy to the machine or equipment were not physically located and operated in such a manner as to isolate the machine or equipment from the energy source(s):   (a)  Machining Area; Machinery such as, but not limited to, the Mazak CNC vertical and horizontal machining centers, the Mazak CNC Slant Turn 25 ATC M/C, and the Super Quick Turn (s/n 107948) were not isolated from energy source(s) when servicing equipment.

Issued

2013-04-25 00:00:00

Abate by

2013-06-12 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(d)(4)(i): Lockout or tagout devices were not affixed to each energy isolating device by authorized employees:   (a)  Machining Area; Machinery such as, but not limited to, the Mazak CNC vertical and horizontal machining centers, the Mazak CNC Slant Turn 25 ATC M/C, and the Super Quick Turn (s/n 107948) did not have lockout or tagout devices affixed to isolating energy device(s) by authorized employee(s).