OSHA Inspection: MCKELLA280, INC.

Issued

2013-05-16 00:00:00

Abate by

2013-08-30 00:00:00

Penalty

Initial $2800.00 · Current $1500.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirements of this standard are being followed.    a) 7025 Central Highway, Pennsauken, NJ 08109 -    An employee authorized to do lockout/tagout procedures was not required to on at least an annual basis to demonstrate that he was following the procedures and requirements of the standard. On or about 03/26/2013.

Issued

2013-05-16 00:00:00

Abate by

2013-08-30 00:00:00

Penalty

Initial $2100.00 · Current $1000.00 Reduced

General-duty citation text

29 CFR 1910.178(g)(2): Facilities were not provided for protecting charging apparatus from damage by trucks.    a) Fork Truck battery charging area -    No facilities were provided for protecting the battery charger and cables from damage by fork trucks. On or about 03/26/2013.

Issued

2013-05-16 00:00:00

Abate by

2013-08-30 00:00:00

Penalty

Initial $2800.00 · Current $1500.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(3)(ii): The point of operation of machines whose operation exposed an employee to injury, was not guarded. The guarding device, where present, was not in conformity with any appropriate standards therefor, or, in the absence of applicable specific standards, was not so designed and constructed as to prevent the operator from having any part of his body in the danger zone during the operating cycle.    a) Press Department -    The Heidelberg press referred to as "The Windmill" which was used for die cutting did not have guarding that would prevent an operator from having a body part in the point of operation during the machine's operating cycle. On or about 03/26/2013.    b) Press Department -     The Heidelberg press labeled as "Original Heidelberg Cylinder" did not have guarding that would prevent an operator from having a body part in the point of operation during the machine's operating cycle. On or about 03/26/2013.

Issued

2013-05-16 00:00:00

Abate by

2013-08-30 00:00:00

Penalty

Initial $3500.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.213(c)(1): Each circular hand-fed ripsaw was not guarded by a hood which shall completely enclose that portion of the saw above the table and that portion of the saw above the material being cut.     a) Press Dept. -    The Hammond table saw did not have a guard to enclose the exposed portion of the blade. On or about 03/26/2013.