OSHA Inspection: CHARLIE WILLIAMS FRAMING

Issued

2013-05-31 00:00:00

Abate by

2013-05-31 00:00:00

Penalty

Initial $1530.00 · Current $918.00 Reduced

General-duty citation text

29 CFR 1926.102(a)(1): Employees shall be provided with eye and face protection equipment when machines or operations present potential eye or face injury from physical, chemical, or radiation agents.       (a)    Back of House - On or about April 17, 2013 an employee was exposed to being struck by flying objects while using a nail gun without eye and face protection.          (b)   Back of House - On or about April 17, 2013 an employee was exposed to being struck by flying objects while using a circular saw without eye and face protection.

Issued

2013-05-31 00:00:00

Abate by

2013-05-31 00:00:00

Penalty

Initial $1530.00 · Current $918.00 Reduced

General-duty citation text

29 CFR 1926.300(b)(2):     Belts, gears, shafts, pulleys, sprockets, spindles, drums, fly wheels, chains, or other reciprocating, rotating or moving parts of equipment shall be guarded if such parts are exposed to contact by employees or otherwise create a hazard. Guarding shall meet the requirements as set forth in American National Standards Institute, B15.1-1953 (R1958), Safety Code for Mechanical Power-Transmission Apparatus.     (a)  Back of Truck - On or about April 17, 2013 an employee was exposed to getting fingers amputated while using an air compressor with unguarded belts and pulleys.

Issued

2013-05-31 00:00:00

Abate by

2013-05-31 00:00:00

Penalty

Initial $1440.00 · Current $864.00 Reduced

General-duty citation text

29 CFR 1926.451(b)(2): Except as provided in paragraphs (b)(2)(i) and (b)(2)(ii) of this section, each scaffold platform and walkway shall be at least 18 inches (46 cm) wide.     (a)  Back of House - On or about April 17, 2013 two employees were exposed to a fall hazard while working on a wooden fabricated scaffold with walkway less than 18 inches. The scaffold walkway was constructed of a 7 inch wide board in one area and a 9 inch wide board in another area.

Issued

2013-05-31 00:00:00

Abate by

2013-05-31 00:00:00

Penalty

Initial $1440.00 · Current $864.00 Reduced

General-duty citation text

29 CFR 1926.1053(b)(13): The top or top step of a stepladder shall not be used as a step.     (a)  Back of House - On or about April 17, 2013 two employees were exposed to a fall hazard while standing on the top step of a step ladder.

Issued

2013-05-31 00:00:00

Abate by

2013-06-19 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.1060(a): The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards.   (a)  Construction Site - On or about April 17, 2013 the employer had not train each employee using ladders on how to recognize, prevent and eliminate fall hazards associated with employees using ladders.