Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: WEATHERFORD PUMPING UNIT

Federal Agency inspection · Safety discipline

On , OSHA opened a federal Agency safety inspection of WEATHERFORD PUMPING UNIT in DENBURY OIL WELL CHSU 11C-36SH 16 APPROXIMATELY TWO MILES EAST OF 89TH STREET, MARMARTH, ND 58643 (NAICS 213112). OSHA activity number 339054819.

Watch Weatherford Pumping Unit — free Get an email when a new federal OSHA severe-injury report for Weatherford Pumping Unit is published. One employer, no account, unsubscribe in one click.
Site address
DENBURY OIL WELL CHSU 11C-36SH 16 APPROXIMATELY TWO MILES EAST OF 89TH STREET
City
MARMARTH
State
ND
ZIP
58643
Mailing
2000 ST. JAMES PLACE, HOUSTON, TX 77056
Inspection type
Federal Agency (M)
Scope
Partial (B)
Discipline
Safety
Advance notice
Yes
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
213112
Employees
67782
Ownership type
A

3 citations on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 123 exposed
Issued
Abate by
Penalty
Initial $7000.00 · Current $7000.00
Section 5(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to being struck by a falling load belt and/or pumping unit parts during servicing activities:  (a) On or about May 1, 2013, for the employees servicing a Rotaflex® pumping unit on oil and gas well locations where one employee was fatally injured after being struck by a falling belt assembly while working under the load where the securing pins were removed prior to the belt assembly being properly restrained at Denbury Oil Well CHSU 11C-36SH 16 approximately two miles east of 89th Street, Marmarth, ND 58643.  Abatement Note: Among other methods, one feasible and acceptable method to correct this hazard would be to follow the manufacturer's established Load Belt Replacement Standard Operating Procedures which states,  "All nonessential personnel should be completely out of the lift area including the area around the well head." and "At no time should load be suspended over personnel."
Recent events (2)
  • — I (S) $7000
  • — Z (S) $7000

1910.180 H04 II

Serious Gravity 10 1 instance 123 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.180(h)(4)(ii): The employer did not ensure that employees were prohibited from standing or passing under a load on the hook:  (a) On or about May 1, 2013, for the employees servicing a Rotaflex® pumping unit on oil and gas well locations where employees were working under a suspended load of the top drum while it was being moved in order to access the load belt assembly during a load belt replacement servicing activity at Denbury Oil Well CHSU 11C-36SH 16 approximately two miles east of 89th Street, Marmarth, ND 58643.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.23 C01

Deleted Serious Gravity 10 1 instance 123 exposed
Issued
Abate by
Penalty
Initial $7000.00 · Current $0.00 Reduced
29 CFR 1910.23(c)(1): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards:    (a) On or about May 1, 2013, for the employees who were working on a platform outside of the counterweight doors on a Rotaflex® pumping unit approximately 15 feet above ground without a means for fall protection while replacing the load belt at Denbury Oil Well CHSU 11C-36SH 16 approximately two miles east of 89th Street, Marmarth, ND 58643.
Recent events (2)
  • — I (S) $0
  • — Z (S) $7000

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339054819.