OSHA Inspection: JAY SANTANA MIRANDA-HERNANDEZ

Issued

2013-08-19 00:00:00

Abate by

2013-08-23 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.403(b)(1): Employer did not ensure that electrical equipment is free from recognized hazards that are likely to cause death or serious physical harm to employees:   On or about May 22, 2013, the employer did not ensure that electrical equipment was free from recognized hazards that were likely to cause death or serious physical harm to employees. Employees were exposed to electrical hazards.    a) The power cord to the 7 1/4-inch Makita Circular Saw (model 5007F, serial #0050815Y) was severed off so the circular saw was wired directly to the extension cord without the ground wire connected.  b) A 100-foot yellow 12-3 AWG extension cord used to power the 7 1/4-inch Makita Circular Saw had strain relief busted at the female end.  c) The 18-inch, 12-3 AWG Extension Cord had ground pin removed.

Issued

2013-08-19 00:00:00

Abate by

2013-08-23 00:00:00

Penalty

Initial $2400.00 · Current $2400.00

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system:   On or about May 22, 2013, one employee was observed working on the outer edge of the framed house without utilizing any fall protection system. The employee was exposed to a fall hazard of greater than six feet.

Issued

2013-08-19 00:00:00

Abate by

2013-09-06 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  On or about May 22, 2013, the employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize those hazards. The employee was exposed to a fall hazard of greater than six feet.