OSHA Inspection: DIGITAL MACHINE CO., INC.

Issued

2013-09-12 00:00:00

Abate by

2013-10-17 00:00:00

Penalty

Initial $1360.00 · Current $680.00 Reduced

General-duty citation text

29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling:     (a) Production Floor - On or about June 11, 2013, electrical equipment was used in a manner for which it was not listed or labeled, in that knockout boxes attached to flexible cords were suspended from the ceiling to provide power to the workstations.

Issued

2013-09-12 00:00:00

Abate by

2013-10-02 00:00:00

Penalty

Initial $1020.00 · Current $510.00 Reduced

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:    (a) Throughout Production - On or about June 11, 2013, where compressed air was used to clean metal shavings from equipment and machinery, the air pressure was not reduced to less than 30 pounds per square inch (p.s.i.).

Issued

2013-09-12 00:00:00

Abate by

2013-10-02 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:   (a)  Lathe Shop - On or about June 11, 2013, the Amada Horizontal Band Saw was powered with a flexible cord which was hard wired into a junction box located on the ceiling.

Issued

2013-09-12 00:00:00

Abate by

2013-10-02 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(c)(7)(iv): The employer did not certify that employee training had been accomplished and kept up to date:  (a) Production Floor - On or about June 11, 2013, authorized level training for employees who perform servicing and maintenance on equipment with sources of hazardous energy, to include the Amada Horizontal Bandsaw, was not certified to demonstrate completion.  (b) Production Floor - On or about June 11, 2013, affected training for employees who operate equipment which are subject to servicing and maintenance and which have sources of hazardous energy, was not certified to demonstrate completion.