OSHA Inspection: WALLACE MOULDING & MILLWORKS, INC.

Issued

2013-07-03 00:00:00

Abate by

2013-07-16 00:00:00

Penalty

Initial $1200.00 · Current $720.00 Reduced

General-duty citation text

29 CFR 1910.178(l)(4)(iii): An evaluation of each powered industrial truck operator's performance shall be conducted at least once every three years:  On or about June 26, 2013, the employer allowed employees to operate the orange Toyota power industrial truck (aka forklift) without the required three year evaluation of the operator's performance.

Issued

2013-07-03 00:00:00

Abate by

2013-07-16 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1910.219(f)(3): Sprocket wheels and chains which were seven -7 feet or less above floors or platforms were not enclosed:(a)(LOCATION)(IDENTIFY SPECIFIC OPERATION(S) AND/OR CONDITIONS)(DESCRIBE HAZARD(S) WHERE NECESSARY):  On or about June 26, 2012, in the  shop area, the employer allowed the employees to use the planner and rip saw to trim the wood without the sprocket and chain, in- going nip point being guarded.

Issued

2013-07-03 00:00:00

Abate by

2013-07-16 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.157(c)(1): Portable fire extinguishers were not mounted, located and identified so that they were readily accessible without subjecting the employees to injuries:(a)(LOCATION)(IDENTIFY SPECIFIC OPERATION(S) AND CONDITION(S))(DESCRIBE HAZARD(S))NOTE: APPLIES WHEREVER EXTINGUISHERS ARE PROVIDED FOR EMPLOYEE USE INCLUDING EXTINGUISHERS ON THE OUTSIDE OF WORKPLACE BUILDINGS OR STRUCTURES:  On or about June 26, 2013, at various locations through out the shop, the employer did not have the portable fire extinguishers mounted nor identified.