OSHA Inspection: SHAWN CISLO

Issued

2013-09-11 00:00:00

Abate by

2013-09-27 00:00:00

Penalty

Initial $1600.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.304(h)(1): Each circular crosscut table saw was not guarded by a hood which completely enclosed that portion of the saw blade above the table and that portion of the saw above the material being cut:  Note:  See paragraph (i)(1) of this section for additional requirements for hand-fed crosscut table saws.          a) On or about 8/15/13, in room 108 of an old two story factory building being converted into apartments at 320 Grote St., Buffalo, NY:  A 10"  Pro-Tech Bench Saw, Model #40028 used to cut laminate lacked a guard on the sawblade.        ABATEMENT CERTIFICATION REQUIRED

Issued

2013-09-11 00:00:00

Penalty

Initial $1020.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.404(f)(6): The path to ground from circuits, equipment, or enclosures was not permanent and continuous:          a) On or about 8/15/13, in room 109 of an old two story factory building being converted into apartments at 320 Grote St., Buffalo, NY: To supply power to a Pro Tech 10" Bench Saw and a Ryobi Mitre Saw, a "bright green" extension cord belonging to Shawn Cislo was plugged into a green adapter in room 109 and run thru the hallway and into room 108 where an orange "Meredyk" adapter was plugged into it. An orange extension cord was plugged into the orange adapter and then a short 3-way extension cord was plugged into the orange cord and powered the saws. The green colored adapter in room 109 lacked a grounding prong which interrupted the path to ground to the saws.         NO ABATEMENT CERTIFICATION REQUIRED

Issued

2013-09-11 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables were used:     a) On or about 8/15/13, in room 108 of an old two story factory building being converted into apartments at 320 Grote St., Buffalo, NY: A series of extension cords/adapters supplied 120 volt-ac power to a Pro-Tech 10" Bench Saw and a Ryobi Mitre Saw. The outer sheath of the orange extension cord in the series was frayed at the female end, exposing the conductors.   NO ABATEMENT CERTIFICATION REQUIRED