OSHA Inspection: JACKSON BUILDINGS

Issued

2013-09-30 00:00:00

Abate by

2013-10-15 00:00:00

Penalty

Initial $1020.00 · Current $612.00 Reduced

General-duty citation text

29 CFR 1910.213(a)(9): All belts, pulleys, gears, shafts, and moving parts were not guarded in accordance with the specific requirements of 1910.219:  On or about September 17, 2013, in the shop area, the table saw did not have the belt and pulley guarded. Employee exposed to a laceration hazard from being caught in the belt and/or pulley while cutting wood.

Issued

2013-09-30 00:00:00

Abate by

2013-10-15 00:00:00

Penalty

Initial $1360.00 · Current $816.00 Reduced

General-duty citation text

29 CFR 1910.213(c)(1): Circular handfed ripsaw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:  On or about September 17, 2013, in the shop area, the table saw did not have an automatic adjusting hood for the blade. Employee exposed to an amputation hazard from being cut by the saw blade when ripping boards.

Issued

2013-09-30 00:00:00

Abate by

2013-10-15 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.213(h)(1): The sides of the lower exposed portion of the blade of radial saw(s) were not guarded to the full diameter of the blade by a device that automatically adjusted itself to the thickness of the stock and remained in contact with the with stock being cut to give maximum protection possible for the operation being performed.  On or about September 17, 2013, in the shop area, the Delta radial arm saw did not have an adjustable bottom guard. Employee exposed to an amputation hazard from the unguarded saw blade. The radial arm saw was a Delta Milwaukee, serial number MX23582.

Issued

2013-09-30 00:00:00

Abate by

2013-10-05 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.213(h)(4): Radial saw(s) were not installed in a manner so as to cause the cutting head to return gently to the starting position when released by the operator:  On or about September 17, 2013, in the shop area, the Delta radial arm saw did not return to the starting position when released. Employee exposed to an amputation hazard from the radial arm saw not returning on its own to the starting position. The radial arm saw was a Delta Milwaukee, serial number MX23582.