OSHA Inspection: JC STONE, INC.

Issued

2014-01-23 00:00:00

Abate by

2014-02-04 00:00:00

Penalty

Initial $1360.00 · Current $680.00 Reduced

General-duty citation text

29 CFR 1910.37(a)(3): Exit route(s) were not kept free and unobstructed:   At the Facility - An exit door is obstructed by a cord running in front of it and, when opened, the exit route leads into the roped off back side of the contour wire saw.

Issued

2014-01-23 00:00:00

Abate by

2014-01-31 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.37(b)(5): Each doorway or passage along an exit access that could be mistaken for an exit was not marked "Not an Exit" or similar designation, or be identified by a sign indicating its actual use (e.g. closet):  Production Area - The door which leads to the Giga saw room had no sign ndicating that it was "not an exit".

Issued

2014-01-23 00:00:00

Abate by

2014-01-29 00:00:00

Penalty

Initial $1700.00 · Current $850.00 Reduced

General-duty citation text

29 CFR 1910.184(d): Damaged or defective sling(s) were not immediately removed from service:   Production Area:  A defective sling, one with the "red" thread showing, had not been taken out of service.

Issued

2014-01-23 00:00:00

Abate by

2014-02-04 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.335(b)(1): 29 CFR 1910.335(b)(1):   Safety signs, safety symbols, or accident prevention tags were not used where necessary to warn employees about electrical hazards which may endanger them:   Production Area - There were no arc flash warning signs on the electrical panels in the room where the contour wire saw is located.