OSHA Inspection: ALLOY WELDING AND FABRICATING

Issued

2014-01-29 00:00:00

Abate by

2014-03-01 00:00:00

Penalty

Initial $1360.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.179(g)(1)(v): Pendant control box(es) were not clearly marked for identification of functions:    a) On or 01/24/2014 in the high bay; where the pendant control button functions on the 10 Ton overhead crane were unreadable/illegible.    ABATEMENT CERTIFICATION REQUIRED

Issued

2014-01-29 00:00:00

Abate by

2014-03-01 00:00:00

Penalty

Initial $1700.00 · Current $1000.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    a) On or about 01/24/2014 in the fabrication area; where the foot pedal on the iron worker was not protected from unintended operation.    ABATEMENT CERTIFICATION REQUIRED

Issued

2014-01-29 00:00:00

Abate by

2014-03-14 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.254(d)(9)(i): The supervisor, when informed by the operator of an equipment defect or safety hazard, did not have the use of the equipment discontinued until its safety had been assured:  a) On or about 01/24/2014 in the fabrication area; where a portable welder being used, had damaged insulation on the ground cable.  ABATEMENT CERTIFICATION REQUIRED

Issued

2014-01-29 00:00:00

Abate by

2014-03-01 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(b)(2)(i): Pull boxes, junction boxes, and fittings were not provided with covers approved for the purpose:  a) On or about 01/24/2014 in the fabrication area; where the the junction box for the steel roller motor was not covered.  ABATEMENT CERTIFICATION REQUIRED