OSHA Inspection: MAURICIO MARTINEZ TREVINO

Issued

2014-04-02 00:00:00

Abate by

2014-04-11 00:00:00

Penalty

Initial $1200.00 · Current $1200.00

General-duty citation text

29 CFR 1926.303(b)(1): Grinding machines were not equipped with safety guards in conformance with the requirements of ANSI B7.1-1970, Safety Code for the Use, Care, and Protection of abrasive wheels, and paragraph (d) of this section.   a) 3812 Hwy. 165, Sterlington, LA; On or about 3/11/14, the employer allowed an employee to operate a Dewalt hand grinder to cut durock board while missing the guard.

Issued

2014-04-02 00:00:00

Abate by

2014-04-09 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as follows:      a) 3812 Hwy. 165, Sterlington, LA; On or about 3/11/14, the employer allowed employees to work from a scaffold level that was not fully planked.

Issued

2014-04-02 00:00:00

Abate by

2014-04-09 00:00:00

Penalty

Initial $2000.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames,  or uprights did not bear on base plates, mud sills or other adequate firm foundation:      a) 3812 Hwy. 165, Sterlington, LA; On or about 3/11/14, the employer allowed employees to work from a scaffold without base plates installed to provide the required support.

Issued

2014-04-02 00:00:00

Abate by

2014-04-09 00:00:00

Penalty

Initial $2000.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.      a) 3812  Hwy. 165, Sterlington, LA; the employer failed to ensure a scaffold used to apply stucco to the exterior of a building was equipped with a ladder for access and egress. The work platform was approximately 13 feet above the ground.

Issued

2014-04-02 00:00:00

Abate by

2014-04-09 00:00:00

Penalty

Initial $2000.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.      a) 3812 Hwy. 165, Sterlington , LA; the employer failed to ensure that a scaffold employees were working from was equipped with a complete guardrail system. The scaffold was 13 feet high.