Safety Incidents OSHA Severe Injury Reports · 2015–2025
2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SHANE M PRATT

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SHANE M PRATT in 2060 MINERAL SPRING AVE, NORTH PROVIDENCE, RI 02911 (NAICS 238170). OSHA activity number 339752743.

Watch Shane M Pratt — free Get an email when a new federal OSHA severe-injury report for Shane M Pratt is published. One employer, no account, unsubscribe in one click.
Establishment
SHANE M PRATT
Site address
2060 MINERAL SPRING AVE
City
NORTH PROVIDENCE
State
RI
ZIP
02911
Mailing
23 B PLEASANT ST, PASCOAG, RI 02859
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238170
Employees
3
Ownership type
A

3 citations on file for this inspection.

1926.100 A

Other-than-serious 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1200.00 · Current $0.00 Reduced
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:    (a) Jobsite: An employee working on the ground and in the vicinity of the scaffold where there was a possible danger of head injury from impact, or falling or flying objects, was not protected by a protective helmet, for a jobsite located in North Providence RI on or about 5-2-14.
Recent events (2)
  • — I (O) $0
  • — Z (S) $1200

1926.451 B05 II

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1600.00 · Current $2000.00
29 CFR 1926.451(b)(5)(ii): The end of a platform greater than 10 feet in length extended over its support more than 18 inches and the platform was not designed and installed so that the cantilevered portion of the platform is able to support employees without tipping, or has guardrails which block employee access to the cantilivered end:    (a) Jobsite: The end of the Werner 2524 24 foot long aluminum scaffold plank extended over its support more than 18 inches on the left and right sides of the scaffold, and the platform was not designed and installed so that the cantilevered portion of the platform was able to support employees without tipping, or had guardrails which blocked employee access to the cantilivered end, for a jobsite located in North Providence RI on or about 5-2-14.
Recent events (2)
  • — I (S) $2000
  • — Z (S) $1600

1926.451 G01 VII

Serious Gravity 10 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2800.00 · Current $0.00 Reduced
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section:    a) Jobsite: An employee working on an aluminum pump jack scaffold, and exposed to a fall of approximately 19 feet, was not protected by the use of a personal fall arrest system or a guardrail system, for a jobsite located in North Providence RI on or about 5-2-14.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2800

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339752743.