OSHA Inspection: AMADOR ABEL JARAMILLO

Issued

2014-08-12 00:00:00

Abate by

2014-09-10 00:00:00

Penalty

Initial $1600.00 · Current $1600.00

General-duty citation text

29 CFR 1926.304(d): Portable, power-driven circular saw(s) were not equipped with a guard above and below the base plate or shoe  At this job site, a Ryobi 7 1/4 inch circular saw, model number CS B134L, number CSI 13375NC10516, was used without its lower guard.

Issued

2014-08-12 00:00:00

Abate by

2014-09-10 00:00:00

Penalty

Initial $1600.00 · Current $1600.00

General-duty citation text

29 CFR 1926.403(b)(2): Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification:  At this job site, a 110 volt receptacle connected to a metal sheathed cable was used to energize a Ryobi, 7 1/4 inch circular saw. The receptacle/outlet was intended for permanent mounting and not meant to be used as a an improvised temporary power source. The receptacle did not have its face plate, employees were exposed to contact with live parts.

Issued

2014-08-12 00:00:00

Abate by

2014-09-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.404(b)(1)(ii): Ground-fault circuit interrupters. All 120-volt, single-phase 15- and 20-ampere receptacle outlets on construction sites, which are not a part of the permanent wiring of the building or structure and which were in use by employees, did not have approved ground-fault circuit interrupters for personnel protection.   At this job site, a Ryobi 7 1/2 inch Ryobi circular saw was energized from a receptacle suspended from a metal sheathed cable; a ground fault circuit interrupter was not used to prevent electrical injuries to employees.

Issued

2014-08-12 00:00:00

Abate by

2014-09-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.405(j)(1)(ii): Fixtures, lampholders, rosettes, or receptacles were not securely supported:  At this job site, a Ryobi 7 1/4 inch circular saw was energized from an electrical outlet which was in mid-air without any support. The receptacle/outlet was connected to a metal sheathed cable and dangling in the air. Employees were exposed to accidental contact with live parts of the outlet.

Issued

2014-08-12 00:00:00

Abate by

2014-09-10 00:00:00

Penalty

Initial $1600.00 · Current $1600.00

General-duty citation text

29 CFR 1926.451(b)(2): Scaffold platforms and walkways were not at least 18 inches wide:   At this job site, employees worked from one-plank, job-made, wooden scaffold platforms less than 18 inches wide. Employees were exposed to falls from the scaffold.