Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: CAS COMPANIES, L.P.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of CAS COMPANIES, L.P. in PORT OF CORPUS CHRISTI, CORPUS CHRISTI, TX 78401 (NAICS 237110). OSHA activity number 339831513.

Watch CAS Companies, L.P. — free Get an email when a new federal OSHA severe-injury report for CAS Companies, L.P. is published. One employer, no account, unsubscribe in one click.
Establishment
CAS COMPANIES, L.P.
Site address
PORT OF CORPUS CHRISTI
City
CORPUS CHRISTI
State
TX
ZIP
78401
Mailing
1442 CLIFF MAUS, CORPUS CHRISTI, TX 78405
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
237110
Employees
35
Ownership type
A

3 citations on file for this inspection.

1926.652 A01

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $4900.00 · Current $4900.00
29 CFR 1926.652(a)(1): Each employee in an excavation was not protected from cave-ins by an adequate protective system designed in accordance with 29 CFR 1926.652(c). The employer had not complied with the provisions of 29 CFR 1926.652(b)(1)(i) in that the trench was not sloped at an adequate angle:    At this job site two employees worked in a trench greater than 5 foot deep without a protective system. The west and south walls of the trench were vertical.
Recent events (2)
  • — I (O) $4900
  • — Z (S) $4900

1926.1053 B01

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2100.00 · Current $2100.00
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigied support that will not deflect, and/or a grasping device was not provided to assist emmployees in mounting and dismounting the ladder    At this job site a section of a metal, portable ladder was used to egress from a trench greater than 5 foot in depth. The ladder section's side rails did not extend 3 feet above ground level. There was no grab bar for employees to hold onto when mounting and dismounting the ladder section.
Recent events (2)
  • — I (O) $2100
  • — Z (S) $2100

1926.1053 B16

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1053(b)(16): Portable ladders with structural defects, such as, but not limited to, broken or missing rungs, cleats, or steps, broken or split rails, corroded components, or other faulty or defective components, were not either immediately marked in a manner that readily identifies them as defective, or tagged with "Do Not Use" or similar language, and were not withdrawn from service until repaired:    At this job side a section of a portable metal ladder which had a damaged side rail was used for employee access to the trench and egress from the trench. Where the side rails rested on the floor of the trench the right hand side rail was bent and did not rest evenly on the trench floor. The ladder section had not been taken out of service or tagged or marked that it was not for use.
Recent events (2)
  • — I (O) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339831513.