Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: WENDELTA INC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of WENDELTA INC in 310 HIGHWAY 80 EAST, CLINTON, MS 39056 (NAICS 722211). OSHA activity number 339831919.

Watch Wendelta INC — free Get an email when a new federal OSHA severe-injury report for Wendelta INC is published. One employer, no account, unsubscribe in one click.
Establishment
WENDELTA INC
Site address
310 HIGHWAY 80 EAST
City
CLINTON
State
MS
ZIP
39056
Mailing
263 WAGNER PLACE, MEMPHIS, TN 38103
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
722211
Employees
37
Ownership type
A

2 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 3 exposed
Issued
Penalty
Initial $3400.00 · Current $1870.00 Reduced
OSH ACT of 1970 Section (5)(a)(1): Section 5(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards because of misusing portable ladders.    (a) 310 Highway 80 East in Clinton, MS - On or about July 1, 2014, employees were exposed to fall hazards because the fiberglass reinforced extension ladder did not extend 36 inches above the cooler.
Recent events (2)
  • — I (S) $1870
  • — Z (S) $3400

1910.26 C01

Serious Gravity 5 1 instance 3 exposed
Issued
Penalty
Initial $4250.00 · Current $2330.00 Reduced
29 CFR 1910.26(c)(1): Good safe practices in the use and care of ladder equipment were not employed by the users to get maximum serviceability, safety, and to eliminate unnecessary damage of equipment:    (a) 310 Highway 80 East in Clinton, MS - On or about July 1, 2014, employees were exposed to fall hazards from a 6 foot metal step ladder because top step and top cap was being used to access the roof, the ladder step ladder was not fully opened with the spreader bars locked in place, and the ladder did not extend 36 inches above the landing on the roof.    Among others, one feasible and useful abatement method to correct these hazards is to; train employees in the proper selection and use of portable ladders as required in ANSI A14.2 - 2000 for portable metal ladders.
Recent events (2)
  • — I (S) $2330
  • — Z (S) $4250

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339831919.