OSHA Inspection: EWERTON LUIZ SILVA DE OLIVERIA

Issued

2014-11-07 00:00:00

Abate by

2014-11-14 00:00:00

Penalty

Initial $1600.00 · Current $1600.00

General-duty citation text

29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents:  a) Jobsite - Employees using multiple pieces of equipment, including but not limited to a Makita circular saw and a pneumatic nail gun, were exposed to eye injuries as eye protection was not provided and utilized during residential construction activities.  Observed on or about 7/8/14

Issued

2014-11-07 00:00:00

Abate by

2014-11-14 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.404(b)(1): The employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites. These requirements are in addition to any other requirements for equipment grounding conductors:  a) Jobsite, 101-107 Fairmount Avenue - An employee was using a Makita saw (model number 50077F serial number 122119) without a GFCI and/or an assured equipment grounding conductor program, observed on or about 7/8/14.

Issued

2014-11-07 00:00:00

Abate by

2014-11-14 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.404(f)(6): The path to ground from circuits, equipment, or enclosures was not permanent and continuous:  a) Jobsite, 101-107 Fairmount Avenue - An employee was exposed to a shock hazard while using a Makita saw (model number 50077F) that was connected to an extension cord that was missing a ground prong, observed on or about 7/8/14.

Issued

2014-11-07 00:00:00

Abate by

2014-11-14 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.501(b)(4): Each employee on walking/working surfaces was not protected from falling through holes (including skylights), more than six feet (1.8 m) above lower levels, by personal fall arrest systems, covers, or guardrail systems erected around such holes:  a) Jobsite, 101-107 Fairmount Avenue, Units 1 and 2 - Employees were performing carpentry operations within 2 feet of unprotected floor holes (7 feet in length by 8 feet in width), 9 feet above the next level without fall protection, observed on or about 7/8/14.

Issued

2014-11-07 00:00:00

Abate by

2014-11-14 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:  a) Jobsite, 101-107 Fairmount Avenue - Employees were performing carpentry operations within 2 feet of unprotected edges, 12 feet above the next level without fall protection, observed on or about 7/8/14.

Issued

2014-11-07 00:00:00

Abate by

2014-11-28 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) Jobsite, 101-107 Fairmount Avenue - Employees were performing carpentry operations within 2 feet of unprotected edges, 12 feet above the next level without being trained in fall protection. Employees did not know the trigger height for fall protection in construction, observed on or about 7/8/14.