OSHA Inspection: NY PREFERRED DEVELOPMENT GROUP LLC

Issued

2015-03-09 00:00:00

Penalty

Initial $2000.00 · Current $1400.00 Reduced

General-duty citation text

29 CFR 1926.403(g): Electrical equipment which was used did not have the manufacturer's name, trademark, or other descriptive marking by which the organization responsible for the product could be identified:    a) On or about February 26, 2015 - Job site at 232-01 Northern Blvd, Douglaston, NY 11363    Employer permitted an employee to use a Bosch hammer drill that did not have a legible manufacturers label with the    name, trademark, or other descriptive markings.    WRITTEN ABBATEMENT CERTIFICATION IS NOT REQUIRED.

Issued

2015-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.404(a)(2): A grounded conductor was attached to a terminal or lead so as to reverse designated polarity:  a) On or about February 26, 2015 - Job site at 232-01 Northern Blvd, Douglaston, NY 11363  Employer permitted an employee to use a Bosch hammer drill that was attached to a flexible cord set with a reversed hot   and neutral polarity.  WRITTEN ABBATEMENT CERTIFICATION IS NOT REQUIRED.

Issued

2015-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws:  a) On or about February 26, 2015 - Job site at 232-01 Northern Blvd, Douglaston, NY 11363  Employer permitted an employee to use a Bosch hammer drill that was attached to a flexible cord set with damaged strain   relief.  WRITTEN ABBATEMENT CERTIFICATION IS NOT REQUIRED.

Issued

2015-03-09 00:00:00

Penalty

Initial $2000.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.404(b)(1)(ii): On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupters for personal protection:    a) On or about February 26, 2015 - Job site at 232-01 Northern Blvd, Douglaston, NY 11363    Employer permitted an employee to use a Bosch hammer drill that was attached to a flexible cord set without GFCI     protection.    WRITTEN ABBATEMENT CERTIFICATION IS NOT REQUIRED.

Issued

2015-03-09 00:00:00

Penalty

Initial $2000.00 · Current $1400.00 Reduced

General-duty citation text

29 CFR 1926.701(b): All protruding reinforcing steel, onto and/or into which employees could fall or come against, was not guarded to eliminate the hazard of impalement:    a) On or about February 26, 2015 - Job site at 232-01 Northern Blvd, Douglaston, NY 11363    The employer permitted their employees to work above and around unguarded rebar.    WRITTEN ABBATEMENT CERTIFICATION IS NOT REQUIRED.