OSHA Inspection: DURA-LITE ALUMINUM PRODUCTS INC.

Issued

2015-09-24 00:00:00

Abate by

2015-11-12 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:   a) 2143 Cameron St., Lafayette, LA; On or about August 26, 2015, the employer did not develop written procedures with specific steps for the control of potentially hazardous energy regarding machines and equipment such as, but not limited to:       1. GED miter saw       2. GED notch saw       3. Greller cleaning machine

Issued

2015-09-24 00:00:00

Abate by

2015-10-08 00:00:00

Penalty

Initial $900.00 · Current $540.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s):   a) 2143 Cameron St., Lafayette, LA; On or about August 26, 2015, the employer failed to ensure a Central Machinery drill press had a guard around the bit.

Issued

2015-09-24 00:00:00

Abate by

2015-10-08 00:00:00

Penalty

Initial $1800.00 · Current $1080.00 Reduced

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:   a) 2143 Cameron St., Lafayette, LA; On or about August 26, 2015, air nozzles are routinely used for cleaning purposes at compressed air pressures up to 95 psig.

Issued

2015-09-24 00:00:00

Abate by

2015-10-08 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.303(f)(2): Each service, feeder, and branch circuit, at its disconnecting means or overcurrent device, was not legibly marked to indicate its purpose, nor located and arranged so the purpose was evident:   a) 2143 Cameron St., Lafayette, LA; On or about August 26, 2015, the employer failed to ensure that the individual breakers inside the electrical panel in the rear of the facility were labeled.