OSHA Inspection: JH TRAFFIC CONTROL CO., LLC

Issued

2015-11-05 00:00:00

Abate by

2015-12-03 00:00:00

Penalty

Initial $2800.00 · Current $0.00 Reduced

General-duty citation text

OSH ACT of 1970 Section (5)(a)(1): : The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that employees were exposed to struck by hazards from vehicles.   (a)  Broadway Avenue:  On September 22, 2015, and at times prior thereto, employees were exposed to the hazards of being struck by public traffic when crossing live traffic lanes while setting and/or retrieving traffic devices.  (b) Broadway Avenue: On September 22, 2015, and at times prior thereto, employees set up traffic control barriers (candles or barrels) working from the downstream end of the area to be closed.  Note: Abatement certification AND supporting documentation are required for this item.

Issued

2015-11-05 00:00:00

Abate by

2015-12-03 00:00:00

Penalty

Initial $2800.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.200(g)(1):  At this job site, the construction area had not been posted with legible traffic signs at points of hazards prior to beginning work.  (a) West University Drive:  On September 22, 2015, and at times prior thereto, the employer did not ensure advance warning signs were established and not obscured from view by trees and/or shrubbery.  Note:  Abatement certification AND supporting documentation are required for this item.

Issued

2015-11-05 00:00:00

Abate by

2015-12-03 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.200(g)(2): All traffic control signs and devices used for protection of the workers did not conform to Part VI of the Manual on Uniform Traffic Control Devices (MUTCD) 1988 Edition, Revision 3:  (a)  Broadway Avenue:  On or about September 22, 2015 and at times prior thereto, the arrow board was not placed at the beginning of the taper.   Note: Abatement certification AND supporting documentation are required for this item.