OSHA Inspection: PRO - MAR CONSTRUCTION, INC.

Issued

2015-11-12 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1926.404(b)(1)(ii):  Where an assured equipment grounding program was not utilized, receptacles were not protected with ground fault circuit interrupters when on a two-wire, single- phase portable or vehicle-mounted generator rated more than 5kW, or where the circuit conductors of the generator were not insulated from the generator frame and all other grounded surfaces:      a)  Employees were using three-wire 120/240 Volt, Honda EM 5000S Portable Generator with receptacle not protected with ground fault circuit interrupters to power tools onsite.    No abatement certification or documentation is required for this item.

Issued

2015-11-12 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.404(f)(6):  The path to ground from circuits, equipment, or enclosures was not permanent and continuous:    a)  Extension cords, used by employees during carpentry work, did not have permanent and continuous path to ground.  No abatement certification or documentation is required for this item.

Issued

2015-11-12 00:00:00

Penalty

Initial $2800.00 · Current $1680.00 Reduced

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):      a)  Employees engaged in carpentry work were not protected from fall hazards while working at an elevation of approximately 17 feet above the ground.     No abatement certification or documentation is required for this item.

Issued

2015-11-12 00:00:00

Abate by

2015-12-16 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1926.503(a)(1):  The employer did not provide a training program for each employee who might be exposed to fall hazards:       a)  Employer did not provide training to each employee in order to recognize hazards associated with working at an elevation and to understand procedures to control or minimize those hazards.       In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2015-11-12 00:00:00

Penalty

Initial $2000.00 · Current $1200.00 Reduced

General-duty citation text

29 CFR 1926.1053(a)(1)(ii): Job-made Ladder was not built in conformance with the applicable provisions of Appendix A:       a)  Employees were using a job-made ladder to access the deck.  The ladder was not built in conformance with Appendix A which references American National Standards Institute (ANSI), A 14.4-1979 - Safety Requirements for Job-Made Ladders.       No abatement certification or documentation is required for this item.