OSHA Inspection: JUST RIGHT AUTO DEALS, LLC

Issued

2016-04-19 00:00:00

Abate by

2016-05-27 00:00:00

Penalty

Initial $4900.00 · Current $3920.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:    (a) 1226 Bankhead Highway #A, Carrollton, GA. 30116, The employer failed to establish a lockout/tagout program which consisted of energy control procedures, employee training and periodic inspections regarding servicing or maintenance on vehicles. An employee was removing a power steering gearbox from a 2001 Chevrolet Tahoe truck, (VIN 1GNEC13T31J177170), supported by two concrete blocks. The employee was crushed between the ground and the A-Frame of the vehicle, resulting in fatal injuries.

Issued

2016-04-19 00:00:00

Abate by

2016-05-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.215(a)(4): Work rest(s) on grinding machinery were not adjusted closely to the wheel with a maximum opening of one eighth of an inch:  (a) Facility located at the Shop 1226 Bankhead Hwy #A., Carrollton, GA. 30116: The work rest on the bench grinder (Performance Tool: 6 Bench Grinder, ½ HP, 115 V) was approximately 2 3/4 inches from the grinding wheel, exposing employees to cuts and lacerations.

Issued

2016-04-19 00:00:00

Abate by

2016-05-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.37(b)(2): Each exit was not clearly visible and marked by a sign reading "Exit":  (a) 1226 Bankhead Hwy #A., Carrollton, GA. 30116: The front exit to the office and mechanic shop was not identified with a sign reading EXIT.

Issued

2016-04-19 00:00:00

Abate by

2016-05-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to the joints or terminal screws:  (a) Shop area at 1226 Bankhead Hwy #A., Carrollton, GA. 30116: Employees were using a Kenmore Dryer (220 Volts) and strain relief was not provided at the terminal end of the cord. Employees were exposed to an electrical shock hazard.

Issued

2016-04-19 00:00:00

Abate by

2016-05-27 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met:    (a) Facility located at 1226 Bankhead Hwy #A., Carrollton, GA. 30116: The employer did not develop, implement, and maintain a hazard communication program when employees were using detailing cleaning products containing amides and amine oxides.