OSHA Inspection: KALNIN GRAPHICS, INC.

Issued

2016-06-02 00:00:00

Abate by

2016-08-01 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:    a) Production Work Area: On or about April 12, 2016, employees are operating and servicing production equipment, such as, but not limited to, the Heidelberg Paper press Machine where lockout/tag out hardware and procedures were used, but a periodic inspection in the last 12 months of the energy control procedures was not conducted and documented.

Issued

2016-06-02 00:00:00

Abate by

2016-06-21 00:00:00

Penalty

Initial $2000.00 · Current $2800.00

General-duty citation text

29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o):    a) The Production Work Area:  On or about April 12, 2016, employees were using a Heidelberg Paper Press Machine which had an unguarded pulley, which created a nip point.

Issued

2016-06-02 00:00:00

Abate by

2016-06-21 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.219(e)(1)(i): Horizontal belts which had both runs seven feet or less from the floor level were not guarded with a guard that extended to at least fifteen inches above the belt:    a) The Production Work Area:  On or about April 12, 2016, employees were using a Heidelberg Paper Press Machine which had an unguarded belt, which created an nip point.

Issued

2016-06-02 00:00:00

Penalty

Initial $1360.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(5): Fan blade guard(s) were not provided where the periphery of the blades was less than seven feet from the floor or working level:    a) The Press Room/Work Shop: On or about April 12, 2016, a wall-mounted exhaust fan was located six (6) feet above the floor with fan blade openings greater than one-half (1/2) inch.

Issued

2016-06-02 00:00:00

Abate by

2016-06-21 00:00:00

Penalty

Initial $1600.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    a) The Production Work Shop: On or about April 12, 2016, employees are using Lawson Super Duty Paper Drill which was not guarded at its point of operation.