Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: DAVID BURCH CONTRACTOR, LLC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of DAVID BURCH CONTRACTOR, LLC. in 439 WILSON AVE., MORGANTOWN, WV 26501 (NAICS 238160). OSHA activity number 341647162.

Watch David Burch Contractor, LLC. — free Get an email when a new federal OSHA severe-injury report for David Burch Contractor, LLC. is published. One employer, no account, unsubscribe in one click.
Site address
439 WILSON AVE.
City
MORGANTOWN
State
WV
ZIP
26501
Mailing
2 SAYLOR ROAD, MORGANTOWN, WV 26501
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
3
Ownership type
A

4 citations on file for this inspection.

1926.501 B13

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $1400.00 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):    a.)  David Burch Contractor, LLC., 439 Wilson Ave. Morgantown WV:  On or about 07/22/16, employees were not protected from falling 28' to the ground while installing shingles on a residential roof.
Recent events (3)
  • — F (S) $1400
  • — C (S) $2000
  • — Z (S) $2000

1926.502 D17

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1600.00 · Current $1120.00 Reduced
29 CFR 1926.502(d)(17): The attachment point of the body harness was not located in the center of the wearer's back near shoulder level, or above the wearer's head:    a.)  David Burch Contractor, LLC., 439 Wilson Ave, Morgantown WV:  On or about 07/22/16, the employee wearing a full body harness  was using a point of attachment on the front of his harness.
Recent events (3)
  • — F (S) $1120
  • — C (S) $1600
  • — Z (S) $1600

1926.503 A01

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $1400.00 Reduced
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:    a.)  David Burch Contractor, LLC., 439 Wilson Ave., Morgantown WV:  On or about 07/22/16, employees were not provided with training in the recognition of fall hazards and how to avoid them prior to being required to work on a roof approximately 28' above the ground.
Recent events (3)
  • — F (S) $1400
  • — C (S) $2000
  • — Z (S) $2000

1926.20 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.20(b)(1): A safety and health program was not initiated and maintained to provide compliance with the general safety and health provisions of the standard:    a.)  David Burch Contractor, LLC., On or about 07/22/16, A safety and health program had not been initiated and maintained which addressed the following basic elements:       1.  Management Commitment to Leadership          A.  Policy statement:  goals established, issued, and communicated to employees.          B.  Program Reviewed Annually.          C.  Participation in safety meetings, inspections; agenda item in meetings.          D.  Adequate commitment of resources.          E.  Safety rules and procedures incorporated into site operations.          F.  Management observations of safety rules.    2.  Assignment of Responsibility           A.  Safety designee on site, knowledgeable, and accountable.          B.  Supervisors' (including foremen) safety and health responsibilities understood.          C.  Employees adherence to safety rules.    3.  Identification and Control of Hazards          A.  Periodic site inspection program involving supervisors.          B.  Preventive controls in place (PPE, Maintenance, Engineering Controls)          C.  Action taken to address hazards.          D.  Safety Committee, where appropriate.          E.  Technical reference materials available.    4.  Training and Education          A.  Supervisors receive basic safety and health training.          B.  Specialized training taken when needed.          C.  Existence of an employee training program, which is on going and effective.    5.  Recordkeeping and Hazard Analysis          A.  Records maintained of employee illnesses/injuries, and posted.          B.  Supervisors perform incident investigations, determine causes, and purpose corrective action.          C.  Injuries, near misses, and illnesses are evaluated for trends, similar causes; corrective action initiated.    6.  First Aid and Medical Assistance          A.  First aid supplies and medical services available.           B.  Employees informed of medical results.          C.  Emergency procedures and training, where necessary.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

UNKNOWN

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341647162.