OSHA Inspection: TRIUMPH FABRICATION-HOT SPRINGS, INC.

Issued

2017-05-16 00:00:00

Abate by

2017-05-31 00:00:00

Penalty

Initial $12675.00 · Current $7000.00 Reduced

General-duty citation text

29 CFR 1910.213(c)(3): Hand-fed ripsaw(s) did not have non kickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator:    On or about January 12, 2017 and at times prior thereto, at the building #2 shipping department, at 1923 Central Avenue, Hot Springs, Arkansas, the # 1 table saw was not equipped with non kickback fingers. This condition exposed employees to amputation hazards.

Issued

2017-05-16 00:00:00

Abate by

2017-05-31 00:00:00

Penalty

Initial $9054.00 · Current $4000.00 Reduced

General-duty citation text

29 CFR 1910.303(g)(1)(i)(B): For electric equipment operating at 600 volts, nominal, or less to ground, and likely to require examination, adjustment, servicing, or maintenance while energized, the width of the working space in front of electrical equipment was less than the width of the equipment or 762 mm (30 inches), whichever was greater:    On or about January 12, 2017 and at times prior thereto, at the building #2 shipping department, the electrical service disconnect for the #1 table saw was blocked by a rack of wooden boards. This condition would delay the timely shutoff of the table saw in the event of an emergency.