Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: JOSE LUIS GOMEZ-PINA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JOSE LUIS GOMEZ-PINA in (LOT #20) 712 BELLE ISLE DRIVE, ALPHARETTA, GA 30009 (NAICS 238130). OSHA activity number 342333853.

Watch Jose Luis Gomez-Pina — free Get an email when a new federal OSHA severe-injury report for Jose Luis Gomez-Pina is published. One employer, no account, unsubscribe in one click.
Site address
(LOT #20) 712 BELLE ISLE DRIVE
City
ALPHARETTA
State
GA
ZIP
30009
Mailing
1308 GALLERIA LANE, SMYRNA, GA 30080
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

3 citations on file for this inspection.

1926.300 B02

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2173.00 · Current $1304.00 Reduced
29 CFR 1926.300(b)(2): Moving part(s) of equipment exposed to contact by employees or which otherwise created a hazard, were not guarded:    (a) New residential construction on Lot #20, East side of structure near retaining wall: On or about May 11, 2017, and at times prior, the employer exposed employees to amputation hazards while operating a Jenny Air Compressor, in that the belt guard provided was damaged and not covering the moving belts and pulleys as employees used this equipment to power framing nail guns used for framing activities.
Recent events (2)
  • — I (S) $1303.8
  • — Z (S) $2173

1926.501 B13

Serious Gravity 10 1 instance 1 exposed
Issued
Penalty
Initial $3803.00 · Current $2282.00 Reduced
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:    (a) New residential construction, East gable side roof: On or about May 11, 2017, and at times prior, the employer exposed employees to fall hazards of 22-feet while working from a 8/12 pitched roof, in that a fall protection system was not provided to an employee installing 1/2-inch plywood sheathing.
Recent events (2)
  • — I (S) $2281.8
  • — Z (S) $3803

1926.503 A01

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  (a) New residential construction on Lot #20, East gable roof: On or about May 11, 2017, and at times prior, the employer failed to train employees to recognize fall hazards while working at heights over 6-feet on a roof or top plates, in that employees worked without fall protection systems while engaged in framing activities.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342333853.