OSHA Inspection: WORLD CLASS PRECISION PRODUCTS

Issued

2017-09-13 00:00:00

Abate by

2017-10-12 00:00:00

Penalty

Initial $5070.00 · Current $3550.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:    (a) Throughout the facility; The employer did not develop specific procedures to isolate energy sources of machines during servicing and maintenance.

Issued

2017-09-13 00:00:00

Abate by

2017-10-12 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(c)(7)(i): The employer did not provide training to ensure that the purpose and function of the energy control program are understood by employees and that the knowledge and skills required for the safe application, usage, and removal of the energy controls are acquired by employees.  (a) Throughout the facility; The employer did not provide adequate training on the hazardous energy control program.

Issued

2017-09-13 00:00:00

Abate by

2017-10-12 00:00:00

Penalty

Initial $5070.00 · Current $3550.00 Reduced

General-duty citation text

29 CFR 1910.147(d)(3): All energy isolating devices that are needed to control the energy to the machine or equipment were not physically located and operated in such a manner as to isolate the machine or equipment from the energy sources:    (a)Throughout the facility; All energy isolating devices were not physically located and operated in such a manner as to isolate the machine or equipment from the energy sources during cleaning, servicing and maintenance activities.

Issued

2017-09-13 00:00:00

Abate by

2017-10-12 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.147(d)(4)(i): Lockout or tagout devices were not affixed to each energy isolating device by authorized employees:  (a) Throughout the facility; Authorized employees did not affix an energy control device while performing cleaning, servicing and maintenance activities to machines such as but not limited to the SKT 300 CNC turning center serial # G3158-0244.

Issued

2017-09-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws:  (a) North west end of production floor; The yellow extension cord powering the overhead hoist had damaged strain relief.