Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: ZABALA CONSTRUCTION, INC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of ZABALA CONSTRUCTION, INC in 2 CORPORATE DRIVE, PALM COAST, FL 32164 (NAICS 238130). OSHA activity number 342690989.

Watch Zabala Construction, INC — free Get an email when a new federal OSHA severe-injury report for Zabala Construction, INC is published. One employer, no account, unsubscribe in one click.
Site address
2 CORPORATE DRIVE
City
PALM COAST
State
FL
ZIP
32164
Mailing
37616 PERTH DR, ZEPHYRHILLS, FL 33541
Inspection type
Referral (C)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
7
Ownership type
A

3 citations on file for this inspection.

1926.501 B15

Serious Gravity 10 3 instances 5 exposed
Issued
Penalty
Initial $3803.00 · Current $2282.00 Reduced
29 CFR 1926.501(b)(15): Each employee on a walking/working surface 6 feet (1.8 meters) or more above lower levels was not protected from falling by a guardrail system, safety net system, or personal fall arrest system:  a.  On or about October 9, 2017 one employee is installing roof sheathing on a 5:12 pitch steep slope commercial roof structure and is not protected by any means of personal fall protection, guardrails or safety nets, exposing them to falls in excess of 10 feet 8 inches, to the ground below.  b. On or about October 9, 2017 two employees were observed standing on the CMU concrete block exterior wall of Wing B of the project, to secure roof trusses to the walls and were not protected by any means of personal fall protection, guardrails or safety nets, exposing them to falls in excess of 9 feet 4 inches to the ground below.  c. On or about October 10, 2017 two employees were observed standing on the exterior CMU concrete block wall to install truss blocking and bracing, and fascia board, and were not protected by any means of personal fall protection, guardrails or safety nets, exposing them to falls in excess of 9 feet 4 inches to the ground below.
Recent events (2)
  • — I (S) $2281.8
  • — Z (S) $3803

1926.1053 B13

Serious Gravity 10 1 instance 1 exposed
Issued
Penalty
Initial $3803.00 · Current $2282.00 Reduced
29 CFR 1926.1053(b)(13): The top or step of a stepladder was used as a step:  a. On or about October 10, 2017 employees used the top step of a Werner brand 6 foot fiberglass step ladder to gain access to the top plate of the CMU wall 9 feet 4 inches above the ground, where truss blocking and bracing was being completed.
Recent events (2)
  • — I (S) $2281.8
  • — Z (S) $3803

1926.20 B01

Other-than-serious 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.20(b)(1): A safety and health program was not initiated and maintained to provide compliance with the general safety and health provisions of the standard:   a. On or about October 10, 2017 on the work site, the employer did not provide a Safety and Health Plan for employees that covered the following basic element:           1.  Management Commitment and Leadership                        A.  Policy statement: goals established, issued, and communicated to employees.             B.  Program Reviewed Annually.             C.  Participation in safety meetings, inspections; agenda item in meetings.             D.  Adequate commitment of resources.             E.  Safety rules and procedures incorporated into site operations.             F.  Management observations of safety rules.            2.  Assignment of Responsibility                    A.  Safety designee on site, knowledgeable, and accountable.             B.  Supervisors' (including foremen) safety and health responsibilities understood.             C.  Employees adherence to safety rules.            3.  Identification and Control of Hazards                      A.  Periodic site inspection program involving supervisors.             B.  Preventive controls in place (PPE, Maintenance, Engineering Controls).                     C.  Action taken to address hazards.             D.  Safety Committee, where appropriate.             E.  Technical reference materials available.            4.  Training and Education                      A.  Supervisors receive basic safety and health training.             B.  Specialized training taken when needed.             C.  Existence of an employee training program, which is on going and effective.            5.  Recordkeeping and Hazard Analysis                     A.  Records maintained of employee illnesses/injuries, and posted.             B.  Supervisors perform incident investigations, determine causes, propose corrective action.             C.  Injuries, near misses, and illnesses are evaluated for trends, similar causes; corrective action                   initiated.            6.  First Aid and Medical Assistance                A.  First aid supplies and medical services available.             B.  Employees informed of medical results.             C.  Emergency procedures and training, where necessary.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342690989.