Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: MATPRO GROUP, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of MATPRO GROUP, INC. in 6168 GLENWAY AVE., CINCINNATI, OH 45211 (NAICS 238320). OSHA activity number 342764818.

Watch Matpro Group, INC. — free Get an email when a new federal OSHA severe-injury report for Matpro Group, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
MATPRO GROUP, INC.
Site address
6168 GLENWAY AVE.
City
CINCINNATI
State
OH
ZIP
45211
Mailing
1463 HIGHLAND HEIGHTS TRAIL, DACULA, GA 30019
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238320
Employees
2
Ownership type
A

3 citations on file for this inspection.

1926.20 B02

Deleted Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3803.00 · Current $0.00 Reduced
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On November 9, 2017, while operating an aerial lift and working from a commercial roof structure, employees were observed applying stucco onto a commercial exterior structure as there were no frequent and regular inspections being performed by a competent person to ensure the job-site, materials and equipment such as a fall protection systems and/or devices were being maintained and utilized in a safe condition.  In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification.  This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence, or written records.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3803

1926.453 B02 V

Serious Gravity 10 1 instance 1 exposed
Issued
Penalty
Initial $3803.00 · Current $2200.00 Reduced
29 CFR 1926.453(b)(2)(v): A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift.    Note to paragraph (b)(2)(v): As of January 1, 1998, subpart M of this part (1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system. The use of a body belt in a tethering system or in a restraint system is acceptable and is regulated under 1926.502(e).    On November 9, 2017 located on the east side of a commercial exterior structure, an employee was exposed to a fall hazard while working inside a JLG Articulating Boom Lift basket Model 600S without being attached to the boom or basket. Potential fall height was measured to be 10 feet.
Recent events (2)
  • — I (S) $2200
  • — Z (S) $3803

1926.501 B01

Serious Gravity 10 1 instance 1 exposed
Issued
Penalty
Initial $3803.00 · Current $0.00 Reduced
29 CFR 1926.501(b)(1): "Unprotected sides and edges." Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.    Located on the east side of a low pitch commercial roof, an employee was exposed to a fall hazard while standing at the edge of the roof spraying stucco onto a commercial exterior structure not utilizing a fall protection system.  Potential fall height measured to be 13-3.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3803

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342764818.