OSHA Inspection: DAVID CONNER CONSTRUCTION CO., LLC

Issued

2018-03-02 00:00:00

Abate by

2018-03-21 00:00:00

Penalty

Initial $2217.00 · Current $2217.00

General-duty citation text

29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles:  a) On the roof in front of building, on or about November 16, 2017, two employees were observed not wearing eye protection while operating a skill saw and a nail gun, exposed to eye injuries from flying debris.

Issued

2018-03-02 00:00:00

Abate by

2018-03-21 00:00:00

Penalty

Initial $2772.00 · Current $2772.00

General-duty citation text

29 CFR 1926.451(c)(2)(iv): Front-end loaders and similar pieces of equipment were used to support scaffold platforms when they were not specifically designed by the manufacturer for such use:  a) In front of the building, on or about November 16, 2017, two employees were elevated to the roof with an unapproved work platform that was supported by a Genie GTH-644 #N43211 high reach forklift, exposed up to an 11-foot fall hazard.

Issued

2018-03-02 00:00:00

Abate by

2018-03-21 00:00:00

Penalty

Initial $2772.00 · Current $2772.00

General-duty citation text

29 CFR 1926.501(b)(1): Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems:  a) At the front of the building, on or about November 16, 2017, two employees were observed working from the roof deck installing siding boards around the dormer without any means of fall protection, exposed up to an 11-foot fall hazard.

Issued

2018-03-02 00:00:00

Abate by

2018-03-21 00:00:00

Penalty

Initial $2217.00 · Current $2217.00

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) On the roof, on or about November 16, 2017, the employer did not have a fall protection training program that addressed the recognition of fall hazards and fall protection methods when work was performed from the roof, exposing employees to an 11-foot fall hazard.

Issued

2018-03-02 00:00:00

Abate by

2018-03-21 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws:  a) At the job site, on or about November 16, 2017, the end of the extension cord that was attached to the electrical receptacle outlet box was missing strain relief, exposing employees to electrical hazards.