Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: DZEN SHEET METAL CONTRACTORS, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of DZEN SHEET METAL CONTRACTORS, INC. in 376 TOLLAND TURNPIKE, MANCHESTER, CT 06042 (NAICS 238160). OSHA activity number 343028940.

Watch Dzen Sheet Metal Contractors, INC. — free Get an email when a new federal OSHA severe-injury report for Dzen Sheet Metal Contractors, INC. is published. One employer, no account, unsubscribe in one click.
Site address
376 TOLLAND TURNPIKE
City
MANCHESTER
State
CT
ZIP
06042
Mailing
74 RANNEY STREET, EAST HARTFORD, CT 06118
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
14
Ownership type
A

3 citations on file for this inspection.

1926.501 B10

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $3696.00 · Current $1848.00 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system.  On or about 03/20/2018 at the 376 Tolland Turnpike Construction Project, an employee was working from the roof decks and was not using a fall protection system.
Recent events (2)
  • — I (S) $1848
  • — Z (S) $3696

1926.1051 A

Serious Gravity 1 1 instance 1 exposed
Issued
Penalty
Initial $2217.00 · Current $1109.00 Reduced
29 CFR 1926.1051(a): Stairway(s) or ladder(s) were not provided at all personnel points of access where there was a break in elevation of 19 inches (48 cm) or more, or no ramp, runway, sloped embankment, or personnel hoist was provided:  On or about 03/20/2018 at the 376 Tolland Turnpike Construction Project, an employee was accessing the lower roof and was stepping down onto the roof deck and the distance was greater than 19 inches.
Recent events (2)
  • — I (S) $1108.5
  • — Z (S) $2217

1926.1053 B16

Other-than-serious 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1053(b)(16): Portable ladders with structural defects, such as, but not limited to, broken or missing rungs, cleats, or steps, broken or split rails, corroded components, or other faulty or defective components, were not either immediately marked in a manner that readily identifies them as defective, or tagged with "Do Not Use" or similar language, and were not withdrawn from service until repaired.  On or about 03/20/2018 at the 376 Tolland Turnpike Construction Project, an employee was using a ladder with a damaged rung and foot and the ladder had not been taken out of service.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View DZEN SHEET METAL CONTRACTORS, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343028940.