OSHA Inspection: JNC SOLUTIONS, LLC

Issued

2018-10-17 00:00:00

Abate by

2018-11-15 00:00:00

Penalty

Initial $1037.00 · Current $1037.00

General-duty citation text

29 CFR 1903.19(c)(1):   The employer failed to certify to OSHA (the Agency) that the following item(s) were abated within 10 calendar days after the abatement date:  JNC Solutions LLC, did not provide abatement certification within 10 calendar days after the abatement date on all the cited items.

Issued

2018-07-19 00:00:00

Penalty

Initial $2217.00 · Current $2217.00

General-duty citation text

29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.  On or about June 20, 2018 an employee was exposed to fall hazards of approximately 10 feet while installing sheathing on a residential home located on the 4200 Block of Crane Dr. Grand Chute, WI.    Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.

Issued

2018-07-19 00:00:00

Abate by

2018-08-16 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.  On or about June 20, 2018 the employer did not provide a training program for employees exposed to fall hazards while engaged in residential construction.

Issued

2018-07-19 00:00:00

Penalty

Initial $2217.00 · Current $2217.00

General-duty citation text

29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.  On or about June 20, 2018, employees utilized an aluminum extension ladder to reach the roof surface of a residential home located on the 4200 Block of Crane Dr. Grand Chute, WI without extending it at least three feet above the upper landing surface.

Issued

2018-07-19 00:00:00

Abate by

2018-08-16 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.1060(a): The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards.  On or about June 20, 2018, the employer did not provide a training program for employees using portable ladders to access upper landing surfaces during residential construction.