OSHA Inspection: WILMER PORTILLO DBA WILMER'S CONSTRUCTION

Issued

2019-01-07 00:00:00

Abate by

2019-01-11 00:00:00

Penalty

Initial $3326.00 · Current $2165.00 Reduced

General-duty citation text

29 CFR 1926.304(f): Section 4.1.2(a) American National Standards Institute 01.1-1961, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Circular hand-fed rip saws were not guarded by an automatically adjusting hood which completely encloses that portion of the saw above the table and above the material being cut:        a) On or about September 12, 2018, a Rockwell table saw was not equipped with a blade guard when used to rip lumber.        In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2019-01-07 00:00:00

Abate by

2019-01-11 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.304(f): Section 4.1.2(c) American National Standards Institute 01.1-1961, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Circular hand-fed rip saws did not have non-kickback fingers on dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator:      a) On or about September 12, 2018, a Rockwell table saw was not equipped with non-kickback fingers or dogs when used to rip lumber.     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2019-01-07 00:00:00

Abate by

2019-01-11 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.304(f): Section 4.1.2(c) American National Standards Institute 01.1-1961, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Circular hand-fed rip saws did not have non-kickback fingers on dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator:        a) On or about September 12, 2018, a Rockwell table saw was not equipped with a spreader when used to rip lumber.        In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2019-01-07 00:00:00

Abate by

2019-01-11 00:00:00

Penalty

Initial $2217.00 · Current $1435.00 Reduced

General-duty citation text

29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet above a lower level were not protected from falling to that lower level:            a) On or about September 12, 2018, employees were exposed to the hazard of falling approximately 12 feet while working from scaffolding without the benefit of fall protection.       In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).