Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: ST. LAWRENCE RESTORATION CO., INC.

Planned inspection · Health discipline

On , OSHA opened a planned health inspection of ST. LAWRENCE RESTORATION CO., INC. in 411 FRANKLIN STREET, CLAYTON, NY 13624 (NAICS 713930). OSHA activity number 343546842.

Watch ST. Lawrence Restoration CO., INC. — free Get an email when a new federal OSHA severe-injury report for ST. Lawrence Restoration CO., INC. is published. One employer, no account, unsubscribe in one click.
Site address
411 FRANKLIN STREET
City
CLAYTON
State
NY
ZIP
13624
Mailing
PO BOX 310, CLAYTON, NY 13624
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
713930
Employees
12
Ownership type
A

7 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 6 instances 5 exposed
Issued
Abate by
Penalty
Initial $2956.00 · Current $2217.00 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of being struck by the load should the overhead hoist, below-the-hook lifting device or bridge crane system fail:     a)  Section No. 1 , on or about 10/18/18: A L20 2 Ton Chain Fall Hoist and a AFF 1.5 Chain Fall Hoist being used to move boat motors had not been inspected on a frequent and periodic basis; had support structures with unknown rated load capacity and had the safety clips missing from the load hooks.    b) Section No. 2, on or about 10/18/18: A Northern 1 Ton Chain Fall Hoist used to move boat parts had not been inspected on a frequent and periodic basis and had support structures with unknown rated load capacity.     c) James Street Building, Refinishing Area No. 1, on or about 10/18/18: A Jet 1 Ton Chain Fall Hoist used to move boat parts had not been inspected on a frequent and periodic basis; had support structures with unknown rated load capacity and had the safety clip missing from the load hook.    d) James Street Building,  Storage Area, on or about 10/18/18:  Two Peerless 2 Ton Chain Fall Hoists; A CM Cyclone 2 Ton Hoist and a American 2 Ton Chain Fall Hoist used to move boats had not been inspected on a frequent and periodic basis;  had support structures with unknown rated load capacity and had the safety clips missing from the load hooks.    e) Building No. 3, on or about 10/18/18: A Duff Lynx 2 Ton Chain Fall Hoist used to move boat parts had not been inspected on a frequent and periodic basis; had support structures with unknown rated load capacity and had the safety clip missing from the load hook.    f) Boat House, on or about 10/18/18: Two Milwaukee 2 Ton Electric Chain Hoists use to move boats had not been inspected on a frequent and periodic basis and had support structures with unknown rated load capacity.
Recent events (2)
  • — I (S) $2217
  • — Z (S) $2956

1910.22 A01

Serious Gravity 1 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2217.00 · Current $1663.00 Reduced
29 CFR 1910.22(a)(1): Place(s) of employment were not kept clean:    a) Carpenter Shop, on or about 10/18/18: Explosive Wood Dust (Class II) was observed in the following areas including but not limited to: floor area surrounding the Grizzly Drill Press.
Recent events (2)
  • — I (S) $1662.75
  • — Z (S) $2217

1910.28 B11 II

Serious Gravity 1 1 instance 2 exposed
Issued
Penalty
Initial $1885.00 · Current $1414.00 Reduced
29 CFR 1910.28(b)(11)(ii): Each flight of stairs having at least 3 treads and at least 4 risers was not equipped with stair rail systems and handrails as required in Table D-2 of this standard:     a) Carpenter Shop, on or about 10/18/18: A flight of stairs with four risers did not have a handrail on the open side.
Recent events (2)
  • — I (S) $1413.75
  • — Z (S) $1885

1910.212 A01

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2956.00 · Current $2217.00 Reduced
29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created point of operation, rotating parts, and flying chips:    a) Carpenter Shop, on or about 10/18/18: Grizzly Drill Press Model 67944 was not provided with a chuck and tool guard.
Recent events (2)
  • — I (S) $2217
  • — Z (S) $2956

1910.303 G02 I

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $2513.00 · Current $1885.00 Reduced
29 CFR 1910.303(g)(2)(i): Live parts of electric equipment operating at 50 volts or more were not guarded against accidental contact by approved cabinets or other forms of approved enclosures, or other means listed under this provision:    a) Section 1, on or about 10/18/18: 120/240 Volt Breaker Panel Box was missing the cover.
Recent events (2)
  • — I (S) $1884.75
  • — Z (S) $2513

1910.304 F01 IV

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.304(f)(1)(iv): Overcurrent devices for circuits rated 600 volts, nominal, or less were not readily accessible to each employee or authorized building management personnel:  a) Section 1, on or about 10/18/2018:  Access to a 120/240 volt breaker panel box was blocked by several pieces of wood and other miscellaneous items.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.37 B02

Other-than-serious 1 instance 3 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.37(b)(2): Each exit was not clearly visible and marked by a sign reading "EXIT":  a)  Carpenter Shop, on or about 10/18/08: The exit door leading to the outside was not marked.  b) Building No. 3, on or about 10/18/18: The exit door leading to the outside was not marked.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343546842.