Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: E & S FRAMING, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of E & S FRAMING, INC. in 1306 SUNNYSLOPE CT. LOT 2 CLOVERLEAF, AUBURN, AL 36830 (NAICS 238130). OSHA activity number 343631883.

Watch E & S Framing, INC. — free Get an email when a new federal OSHA severe-injury report for E & S Framing, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
E & S FRAMING, INC.
Site address
1306 SUNNYSLOPE CT. LOT 2 CLOVERLEAF
City
AUBURN
State
AL
ZIP
36830
Mailing
2908 BIRMINGHAM HIGHWAY, OPELIKA, AL 36801
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

5 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $3326.00 · Current $3326.00
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical agents:  a)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to operate pneumatic nail guns without eye protection while performing framing activities exposing his employees to struck-by hazards.
Recent events (1)
  • — Z (S) $3326

1926.451 B02

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.451(b)(2): Except as provided in paragraphs (b)(2)(i) and (b)(2)(ii) of this section, each scaffold platform and/or walkway was not at least 18 inches (46 cm) wide:  a)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to perform framing activities from a job made scaffold with a work platform that measured 8 inches wide without fall protection exposing his employees to a fall hazard of up to 18 feet to the floor below.
Recent events (1)
  • — Z (S) $3880

1926.451 G01

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:  a)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to perform framing activities from a job made scaffold without fall protection exposing them to a fall hazard of up to 18 feet to the floor below.
Recent events (1)
  • — Z (S) $0

1926.501 B13

Serious Gravity 10 3 instances 5 exposed
Issued
Abate by
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to perform roof decking activities without fall protection exposing them to a fall hazard of 11.8 feet to the ground below.  b)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to perform framing activities from the second floor next to window openings without fall protection exposing them to a fall hazard of up to 14 feet to the ground below.  c)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 27, 2018 and at times prior; the employer allowed his employees to perform framing activities from the second floor next to a floor opening without fall protection exposing them to a fall hazard of up to 12.5 feet to the floor below.
Recent events (1)
  • — Z (S) $3880

1926.1053 B01

Serious Gravity 5 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $2217.00 · Current $2217.00
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  a)  At 1306 Sunnyslope Ct., Lot 2 Cloverleaf, Auburn, Alabama:  On or about November 28, 2018 and at times prior; the employer allowed his employees to use an extension ladder to gain access to the second floor and the rails of the ladder did not extend 3 feet above the landing to provide safe access exposing them to a fall hazard of 12.5 feet to the ground below.
Recent events (1)
  • — Z (S) $2217

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343631883.