OSHA Inspection: CHESTNUT POINT CARE CENTER, LLC

Issued

2020-02-03 00:00:00

Penalty

Initial $3441.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.133(a)(1): Protective eye equipment was not required where there was a reasonable probability of injury that could be prevented by such equipment:    Dietary:  On, or about, December 16, 2019, chemical splash goggles were not provided where Avatar cleaner, a corrosive liquid with a pH of 13.5, was used to clean the grill area.

Issued

2020-02-03 00:00:00

Penalty

Initial $3441.00 · Current $2500.00 Reduced

General-duty citation text

29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling:    Laundry:  On, or about, December 16, 2019, a two wire fan was used in the exhaust duct for the dryer.  The fan was not provided with an equipment grounding conductor.

Issued

2020-02-03 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.304(g)(5): The path to ground from circuits, equipment, and enclosures was not permanent, continuous, and effective:  Dietary:  On, or about, December 16, 2019, the ground pin was missing from the plug on the Marley pedestal fan.

Issued

2020-02-03 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.307(c): Equipment, wiring methods, and installations of equipment in hazardous (classified) locations were not intrinsically safe, approved for the hazardous (classified) location, or safe for the hazardous (classified) location:  Laundry:  On, or about, December 16, 2019, a two wire fan was used in the exhaust duct for the dryer which is  classified as a Class III, Division 2 location due to the presence of easily ignitable fibers/flyings.  The housing around the motor intake was covered with lint.

Issued

2020-02-03 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(2)(iii): Flexible cords were not connected to devices and fittings so that tension would not be transmitted to joints or terminal screws:  Dietary:  On, or about, December 16, 2019, the power cord provided on the Hobart mixer was pulled from the fitting on the back of the machine, exposing the conductors.