Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: DIRECT MATCH PAINT COMPANY

Unprogrammed Related inspection · Safety discipline

On , OSHA opened an unprogrammed Related safety inspection of DIRECT MATCH PAINT COMPANY in 58-60 WOODRIDGE BLVD, FAIRFIELD, OH 45014 (NAICS 238160). OSHA activity number 343767463.

Watch Direct Match Paint Company — free Get an email when a new federal OSHA severe-injury report for Direct Match Paint Company is published. One employer, no account, unsubscribe in one click.
Site address
58-60 WOODRIDGE BLVD
City
FAIRFIELD
State
OH
ZIP
45014
Mailing
474 WATERWORKS RD, WINCHESTER, KY 40391
Inspection type
Unprogrammed Related (G)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
1
Ownership type
A

5 citations on file for this inspection.

1910.178 L01 I

Deleted Serious Gravity 10 1 instance 9 exposed
Issued
Abate by
Penalty
Initial $3978.00 · Current $0.00 Reduced
29 CFR 1910.178(l)(1)(i): The employer shall ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l).  On Dec. 19, 2018, an employee was operating a JLG 6042 Telescopic Forklift that had not received training required by this subpart.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3978

1926.20 B02

Serious Gravity 10 4 instances 9 exposed
Issued
Abate by
Penalty
Initial $3978.00 · Current $3978.00
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On Dec. 19, 2018, there were no frequent and regular inspections being performed by a competent person in that:  (a) employees were using two portable extension ladders as roof access for two 3-story apartment buildings that did not extend 3 feet above the upper landing surface    (b) employees were using a pneumatic nail gun without eye protection    (c) employees were working on a low-slope pitch roof structure at fall heights greater than 23 feet above the ground below without a fall protection system   (d) employees were dropping roof waste over the edge of a roof structure at a height greater than 20 feet above the ground below without use of a waste disposal chute
Recent events (2)
  • — I (S) $3978
  • — Z (S) $3978

1926.501 B10

Serious Gravity 10 1 instance 9 exposed
Issued
Penalty
Initial $3978.00 · Current $0.00 Reduced
29 CFR 1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted.     On Dec. 19, 2018, located throughout the residential roof structures of two 3-story apartment buildings, employees were observed performing roofing work while not utilizing a fall protection system. Potential fall heights were measured to be greater than 23 feet above the ground below.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3978

1926.502 A02

Serious Gravity 10 1 instance 9 exposed
Issued
Penalty
Initial $3978.00 · Current $0.00 Reduced
29 CFR 1926.502(a)(2): Employers shall provide and install all fall protection systems required by this subpart for an employee, and shall comply with all other pertinent requirements of this subpart before that employee begins the work that necessitates the fall protection.    On Dec. 19, 2018, employees were not provided with fall protection equipment before beginning roofing work at potential fall heights greater than 23 feet above the ground below.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3978

1926.503 A01

Serious Gravity 10 1 instance 9 exposed
Issued
Abate by
Penalty
Initial $3978.00 · Current $0.00 Reduced
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    The employer did not provide a training program for employees performing roofing work on a residential roof while not utilizing a fall protection system and exposed to fall heights greater than 23 feet above the ground below.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3978

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343767463.