Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SOUTH TEXAS ILLUMINATION LLC

Federal Agency inspection · Safety discipline

On , OSHA opened a federal Agency safety inspection of SOUTH TEXAS ILLUMINATION LLC in W FWY BLVD S - I-10 FEEDER EASTBOUND AT S. PEACOCK ST., VIDOR, TX 77662 (NAICS 237310). OSHA activity number 343899068.

Watch South Texas Illumination LLC — free Get an email when a new federal OSHA severe-injury report for South Texas Illumination LLC is published. One employer, no account, unsubscribe in one click.
Site address
W FWY BLVD S - I-10 FEEDER EASTBOUND AT S. PEACOCK ST.
City
VIDOR
State
TX
ZIP
77662
Mailing
14308 STATE HIGHWAY 155 N, WINONA, TX 75792
Inspection type
Federal Agency (M)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
237310
Employees
19
Ownership type
A

7 citations on file for this inspection.

1926.251 E08

Serious Gravity 5 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $5304.00 · Current $3182.00 Reduced
29 CFR 1926.251(e)(8): Synthetic web slings were not immediately removed from service if any of the following conditions specified in 1926.251(e)(8)(i) through (e)(8)(v) were present:  (i) Acid or caustic burns; (ii) Melting or charring of any part of the sling surface; (iii) snags, punctures, tears, or cuts; (iv) broken or worn stitches; or (v) distortion of fittings.    a) At the site, on or about March 28, 2019:  a synthetic sling with tears and broken stitches was not removed from service.
Recent events (2)
  • — I (S) $3182.4
  • — Z (S) $5304

1926.1408 A01

Serious Gravity 10 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $9282.00 · Current $5569.00 Reduced
29 CFR 1926.1408(a)(1)(i):  The employer did not identify the work zone by demarcating the boundaries and prohibiting the operator from operating equipment past those boundaries:      a) At the site, on or about March 28, 2019: the employer did not identify the work zone by demarcating boundaries and prohibiting crane operations past those boundaries.
Recent events (2)
  • — I (S) $5569.2
  • — Z (S) $9282

1926.1408 A02

Serious Gravity 10 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1408(a)(2):  The employer did not determine if any part of the equipment, load line or load (including rigging and lifting accessories), if operated up to the equipment's maximum working radius in the work zone, could get closer than 20 feet to a power line, and did not meet requirements listed in 1926.1408 (a)(2)(i-iii) when it could be.    a) At the site, on or about March 28, 2019:  employees were exposed to electrocution hazards when operating a boom truck, Terex, Model BT3470 (SN: 1004BT3470396) without determining if any part of the crane could get within 20 feet from a 7620 volt power line.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1408 A02 III B

Serious Gravity 10 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1408(a)(2)(iii)(B): Where it was determined that any part of the equipment, load line or load (including rigging and lifting accessories), while operating up to the equipment's maximum working radius in the work zone, could get closer than the minimum approach distance of the power line permitted under Table A (see � 1926.1408), the requirements in paragraph (b) of this section were not met:  a) At the site, on or about March 28, 2019:  employees were exposed to electrocution hazards when operating a boom truck, Terex, Model BT3470 (SN: 1004BT3470396) without taking encroachment precautions when the crane or its parts came into contact with power lines.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1427 A02

Serious Gravity 10 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $9282.00 · Current $5569.00 Reduced
29 CFR 1926.1427(a)(2): The employer did not provide certification of crane operators.    a)  At the site: On or about March 28, 2019 the employer did not ensure the operator of the boom truck crane, Terex, Model BT3470 (SN: 1004BT3470396) was certified to operate that type of crane.
Recent events (2)
  • — I (S) $5569.2
  • — Z (S) $9282

1926.1412 E03 I

Other-than-serious 1 instance 7 exposed
Issued
Abate by
Penalty
Initial $744.00 · Current $446.00 Reduced
29 CFR 1926.1412(e)(3)(i): The employer did not document and maintain the results of the monthly inspection including the items checked along with the date and signature of the person performing the inspection.    a) On or about March 29, 2019:  the employer did not document and maintain results of monthly inspections for Boom Truck Crane, Terex, Model BT3470 (SN: 1004BT3470396).
Recent events (2)
  • — I (O) $446.4
  • — Z (O) $744

1926.1412 F02

Other-than-serious 1 instance 7 exposed
Issued
Penalty
Initial $744.00 · Current $446.00 Reduced
29 CFR 1926.1412(f)(2):  The equipment was not inspected by a qualified person at least every 12 months in accordance with paragraphs (f)(2)(i) -- (xxi) of this section.     a)  At the site, on or about March 29, 2019: Boom Truck Crane, Terex, Model BT3470 (SN: 1004BT3470396) was not inspected by a qualified person at least every 12 months.
Recent events (2)
  • — I (O) $446.4
  • — Z (O) $744

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343899068.