Safety Incidents OSHA Severe Injury Reports · 2015–2025
3,913,242Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: HONORIO HERNANDEZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of HONORIO HERNANDEZ in 3001 JOE DIMAGGIO DR BUILDING 1400, ROUND ROCK, TX 78665 (NAICS 238160). OSHA activity number 343918363.

Watch Honorio Hernandez — free Get an email when a new federal OSHA severe-injury report for Honorio Hernandez is published. One employer, no account, unsubscribe in one click.
Establishment
HONORIO HERNANDEZ
Site address
3001 JOE DIMAGGIO DR BUILDING 1400
City
ROUND ROCK
State
TX
ZIP
78665
Mailing
10613 LANSHIRE DRIVE, AUSTIN, TX 78758
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
2
Ownership type
A

5 citations on file for this inspection.

1926.102 A01

Serious Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1705.00 · Current $1194.00 Reduced
1926.102(a)(1): Employees were not provided with eye and face protection equipment when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents:    On or about April 9, 2019, one employee was using a Malco Metal Shears to cut sheet metal and was not wearing safety glasses, exposing the employee to the hazard of being struck by flying debris.
Recent events (2)
  • — I (S) $1193.5
  • — Z (S) $1705

1926.501 B10

Repeat Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3410.00 · Current $2387.00 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems.    On or about April 9, 2019, one employee was installing a sheet metal roof to a commercial property under construction and was not protected from falls over 6 feet.
Recent events (2)
  • — I (R) $2387
  • — Z (R) $3410

1926.503 A01

Repeat Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.503(a)(1): The employer did not train each employee who might be exposed to fall hazards to enable them to recognize fall hazards and the procedures to be followed in order to minimize these hazards:  On or about April 9, 2019,  the employer did not provided training for one employee performing roofing activities on the rooftop of the commercial property under construction, exposing the employee to a fall hazard of approximately 11 feet.
Recent events (2)
  • — I (R) $0
  • — Z (R) $0

1926.1053 B01

Repeat Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3410.00 · Current $2387.00 Reduced
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:    On or about April 9, 2019, one employee accessed the rooftop of the commercial property under construction using an extension ladder not extended 3 feet above the landing surface, exposing the employee to a fall hazard of approximately 11 feet.
Recent events (2)
  • — I (R) $2387
  • — Z (R) $3410

1926.1060 A

Repeat Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would train each employee in the procedures to be followed to minimize hazards related to ladders and stairways:  On or about April 9, 2019, the employer did not provided training to one employee access the rooftop of the commercial property under construction by using a Werner 20 foot extension ladder which was not extended 3 feet above the landing surface, exposing the employee to a fall hazard of approximately 11 feet.
Recent events (2)
  • — I (R) $0
  • — Z (R) $0

View HONORIO HERNANDEZ's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343918363.