OSHA Inspection: JOS? PEREZ MORALES

Issued

2019-07-18 00:00:00

Abate by

2019-08-02 00:00:00

Penalty

Initial $2273.00 · Current $1364.00 Reduced

General-duty citation text

29 CFR 1926.451(a)(6): Scaffolds were not designed by a qualified person and were not constructed and loaded in accordance with that design:    (a) 1818 College Dr., Meridian MS - On or about May 16, 2019 the employer did not ensure that the tubular welded frame scaffold was designed by a qualified person exposing employees to a fall hazard.

Issued

2019-07-18 00:00:00

Abate by

2019-08-02 00:00:00

Penalty

Initial $2273.00 · Current $1364.00 Reduced

General-duty citation text

29 CFR 1926.451(b)(3): The front edge of platforms were more than 14 inches (36 cm) from the face of the work where guardrail systems were not erected along the front edge and/or personal fall arrest systems were not used in accordance with paragraph (g) of this section to protect employees from falling:    (a) 1818 College Dr., Meridian MS - On or about May 16, 2019 the employer allowed employees to work on a tubular welded frame scaffold that was approximately 20 inches away from the face of work without any means of fall protection exposing them to a fall hazard.

Issued

2019-07-18 00:00:00

Abate by

2019-08-02 00:00:00

Penalty

Initial $2273.00 · Current $1364.00 Reduced

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used:    (a) 1818 College Dr., Meridian MS - On or about May 16, 2019 the employer did not provide to employees means of safe access while working from a tubular welded frame scaffold exposing employees to a fall hazard.

Issued

2019-07-18 00:00:00

Abate by

2019-08-02 00:00:00

Penalty

Initial $2273.00 · Current $1364.00 Reduced

General-duty citation text

29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.    (a) 1818 College Dr., Meridian MS - On or about May 16, 2019 the employer did not ensure that employees working on a tubular welded frame scaffold have been trained by a qualified person on the applicable standards or procedures to be followed to minimize scaffolding hazards.