Safety Incidents OSHA Severe Injury Reports · 2015–2025
2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: ENRIQUE LOPEZ PEREZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ENRIQUE LOPEZ PEREZ in 2964 AND 2714 SPRING LAKE CROSSING, OPELIKA, AL 36801 (NAICS 238130). OSHA activity number 344088422.

Watch Enrique Lopez Perez — free Get an email when a new federal OSHA severe-injury report for Enrique Lopez Perez is published. One employer, no account, unsubscribe in one click.
Establishment
ENRIQUE LOPEZ PEREZ
Site address
2964 AND 2714 SPRING LAKE CROSSING
City
OPELIKA
State
AL
ZIP
36801
Mailing
3501 BIRMINGHAM HIGHWAY APT 513, OPELIKA, AL 36801
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
8
Ownership type
A

5 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 1 instance 8 exposed
Issued
Abate by
Penalty
Initial $3410.00 · Current $3410.00
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical agents:  a)  At 2714 and 2694 Spring Lake Crossing, Lot 55 and 54 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to operate pneumatic nail guns without eye protection while performing framing activities exposing his employees to struck-by hazards.
Recent events (1)
  • — Z (S) $3410

1926.451 B02

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3978.00 · Current $3978.00
29 CFR 1926.451(b)(2): Except as provided in paragraphs (b)(2)(i) and (b)(2)(ii) of this section, each scaffold platform and/or walkway was not at least 18 inches (46 cm) wide:  a)  At 2694 Spring Lake Crossing, Lot 54 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities from a job made scaffold with a work platform that measured 12 inches wide exposing his employees to a fall hazard up to 19 feet to the ground below.
Recent events (1)
  • — Z (S) $3978

1926.451 G01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:  a)  At 2694 Spring Lake Crossing, Lot 54 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities without fall protection while working from a job made scaffold exposing his employees to a fall hazard up to 19 feet to the ground below.
Recent events (1)
  • — Z (S) $0

1926.503 A01

Serious Gravity 10 2 instances 8 exposed
Issued
Abate by
Penalty
Initial $3978.00 · Current $3978.00
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a)  At 2714 Spring Lake Crossing, Lot 55 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities without first ensuring his employees were trained on the hazards associated with falls to include but not limited to setting up and inspecting fall protection exposing his employees to a fall hazard up to 21.1 feet to the ground below.  b)  At 2694 Spring Lake Crossing, Lot 54 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities without first ensuring his employees were trained on the hazards associated with falls to include but not limited to setting up and inspecting exposing his employees to a fall hazard up to 10.8 feet to the ground below.
Recent events (1)
  • — Z (S) $3978

1926.501 B13

Serious Gravity 5 2 instances 3 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a)  At 2714 Spring Lake Crossing, Lot 55 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities without fall protection exposing his employees to a fall hazard up to 21.1 feet to the ground below.  b)  At 2694 Spring Lake Crossing, Lot 54 The Springs of Mill Lakes, Opelika, Alabama:  On or about June 18, 2019 and at times prior; the employer allowed his employees to perform framing activities without fall protection exposing his employees to a fall hazard up to 10.8 feet to the ground below.
Recent events (1)
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344088422.