OSHA Inspection: CEDARLINE WOODWORKS/DOVE PROPERTIES LLC

Issued

2019-07-12 00:00:00

Abate by

2019-07-22 00:00:00

Penalty

Initial $2273.00 · Current $1364.00 Reduced

General-duty citation text

29 CFR 1910.213(c)(1): Circular handfed ripsaw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:  On or about June 20, 2019, and at times prior there to, circular handfed ripsaws operated by employees were not adequately guarding to protect employees from flying debris, rotating parts, and the point of operation.  Employees were exposed to struck-by and amputation hazards while operating equipment including but not limited to the following instances:    A. Grizzly 12" Table Saw B. Delta 10" Tilting Arbor Saw

Issued

2019-07-12 00:00:00

Abate by

2019-07-22 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.213(g)(1): Each swing cutoff saw was not provided with a hood that completely enclosed the upper half of the saw, the arbor end, and the point of operation at all positions of the saw:  On or about June 20, 2019, and at times prior there to, employees operated a swing cutoff saw that was not adequately guarded to protect them from flying debris, rotating parts, and the point of operation (bottom of blade).  Employees were exposed to struck-by and amputation hazards.

Issued

2019-07-12 00:00:00

Abate by

2019-07-22 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(a)(2)(ii): Temporary wiring was not removed immediately upon completion of the project or purpose for which the wiring was installed:    On or about June 20, 2019, and at times prior there to, temporary wiring (extension cords) were used as permanent wiring including but not limited to the following instances, exposing employees to electric shock hazards:  A. Orange extension cord near front door entrance of cabinet shop powering the Dewalt 12 inch Miter Saw. B. Yellow extension cord in the middle of the cabinet shop powering the Grizzly 12 inch Table Saw.