OSHA Inspection: GUY METALS, INC.

Issued

2020-03-03 00:00:00

Abate by

2020-03-31 00:00:00

Penalty

Initial $7422.00 · Current $4450.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct an annual or more frequent inspection of the energy control procedure to ensure that the procedure and requirements of this standard were followed:    a) Throughout the production area; The employer did not conduct periodic inspections of the machine specific energy control procedures on at least an annual basis.

Issued

2020-03-03 00:00:00

Abate by

2020-03-31 00:00:00

Penalty

Initial $7422.00 · Current $2975.00 Reduced

General-duty citation text

29 CFR 1910.253(b)(4)(iii): Oxygen cylinders in storage were not separated from fuel-gas cylinders or combustible materials (especially oil or grease), a minimum distance of 20 feet (6.1 m) or by a noncombustible barrier at least 5 feet (1.5 m) high having a fire-resistance rating of at least one-half hour:    (a) Northwest production area, compressed gas cylinder storage location; A full compressed oxygen cylinder was stored within 4 feet from two full acetylene cylinders.

Issued

2020-03-03 00:00:00

Abate by

2020-03-31 00:00:00

Penalty

Initial $7422.00 · Current $4450.00 Reduced

General-duty citation text

29 CFR 1910.333(b)(2)(iii)(A): A lock and a tag was not placed on each disconnecting means used to deenergize circuits and equipment on which work is to be performed, except as provided in paragraphs (b)(2)(iii)(C) and (b)(2)(iii)(E) of this section:    (a) North production area; IMEAS No. 1; On or about December 18, 2019, an employee opened the motor control center (MCC) for IMEAS No. 1 to reset a hydraulic thermal switch without affixing a lock and tag to the electrical disconnect.

Issued

2020-03-03 00:00:00

Abate by

2020-03-31 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.303(e): Markings were not provided on electrical equipment giving voltage, current, wattage, and other ratings as necessary:  (a) North production area; Motor control centers (MCCs) for IMEAS No. 1, IMEAS No. 2 and IMEAS No. 3 were not provided with markings to indicate electrical equipment voltage, current, wattage, and other necessary ratings.