OSHA Inspection: CARLOS CASTRO MALDONADO

Issued

2020-12-10 00:00:00

Abate by

2021-01-07 00:00:00

Penalty

Initial $3470.00 · Current $3470.00

General-duty citation text

29 CFR  1926.100(a):Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:  (a)   This violation occurred on or about December 1, 2020, at the job-site located at 2004 Bonte Drive, Forney, TX; where employees were framing a new residential single family house and were exposed to head injuries where overhead hazard exists by not wearing hard hats.

Issued

2020-12-10 00:00:00

Abate by

2021-01-07 00:00:00

Penalty

Initial $3470.00 · Current $3470.00

General-duty citation text

29 CFR  1926.102(a)(1): Employees were not provided with eye and face protection equipment when machines or operations present potential eye or face injury from physical, chemical, or radiation agents:  (a)  This violation occurred on or about December 1, 2020, at the job-site located at 2004 Bonte Drive, Forney, TX; where employees framing a new residential single family house and operating hand and powered tools did not wear eye protection.

Issued

2020-12-10 00:00:00

Abate by

2021-01-07 00:00:00

Penalty

Initial $4048.00 · Current $4048.00

General-duty citation text

29 CFR  1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501(b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:   This violation occurred on or about December 1, 2020, at the job-site located at 2004 Bonte Drive, Forney, TX;   where employees doing framing work and were exposed to fall hazards:  (a)	Employees were exposed to fall hazards at 10-feet; (b)	Employees were exposed to fall hazards at 20-feet.